Question is ⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is, Options are ⇒ (A) 0.76, 0.24, (B) 0.95, 0.3, (C) 0.24, 0.76, (D) 0.3, 0.95, (E) , Leave your comments or Download question paper.

Question is ⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is, Options are ⇒ (A) 0.76, 0.24, (B) 0.95, 0.3, (C) 0.24, 0.76, (D) 0.3, 0.95, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
A.	0.76, 0.24 [Wrong Answer]
B.	0.95, 0.3 [Correct Answer]
C.	0.24, 0.76 [Wrong Answer]
D.	0.3, 0.95 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An audio frequency of 5 kHz is translated to a radio frequency carrier of frequency 1 MHz and transmitted it to space through an antenna. The required height of antenna is
150 m
300 m
75 m
600 m

⇒

Assertion (A): In intrinsic semiconductors, the charge concentration increases with temperature.

Reason (R): At higher temperatures, the forbidden energy gap in semiconductors is lower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ When the ac input signal is very large the instantaneous operating point CE amplifier moves all the way between
ac saturation and ac cut off points
ac operating and ac cut off points
ac saturation and ac operating points
none of the above

⇒ Which of the following has highest conductivity?
Silver
Aluminium
Tungsten
Platinum

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ Tropospheric scatter propagation is not subject to any fading.
TRUE
FALSE

⇒ In a series operated thyristor configuration, each thyristor should support 100 V. However, the three thyristors only support voltage of 100 V, 90 V and 85 V respectively. Hence, the string efficiency in the case is :
0.9845
0.4584
0.9167
none of these

⇒ The sampling frequency in CD is 10 kHz.
TRUE
FALSE

⇒ The circuit show in the figure has 4 boxes each described by inputs P, Q, R and outputs y, z
4 bit adder giving P + Q
4 bit subtractor P - Q
4 bit subtractor Q - P
4 bit adder P + Q + R

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒ Figure shows the terminals of a transistor in plastic package TO 18. T
terminals 1, 2, 3 are emitter, collector, base respectively
terminals 1, 2, 3 are emitter, base, collector respectively
terminals 1, 2, 3 are base, emitter collector, respectively
terminals 1, 2, 3 are collector, emitter, base respectively

⇒ Which of the following integer expressions is correct in Pascal?
- A + B + M
A div B * mod C
A - 4.0
A / B + D

⇒

Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a pneumatic bellows
the input surface, output surface and side walls are corrugated
the input surface and output surface are flat but the side walls are corrugated
the input surface and side walls are flat but the output surface is corrugated
the input surface and output surface are corrugated but the side walls are flat

⇒ In electromagnetic wave polarization is caused by
refraction
reflection
longitudinal nature of electromagnetic waves
transverse nature of electromagnetic waves

⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other

⇒ Consider the circ
0
(C + D)
1
(A + B) + (C + D)

⇒ In figure, the voltmeter is ideal. The transformer has two identical windings with perfect coupling. The reading of voltmete
440 V
220 V
110 V
zero

⇒ In figure, the current through R is 1 A when V_A = 0 and V_B = 15V. If both V_A and V_B are increased by 15V each, current through R wil
0.0416666666666667
0.5 A
0.125
0.33 A

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒ The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this mod
Two times its band rate
Four times its band rate
Same as band rate
Sufficient information is not given to give the answer

⇒ An oscillator at 4.2 MHz is followed by two frequency doublers and two triplers. The output frequency will be
84 MHz
112.4 MHz
151.2 MHz
303.4 MHz

⇒ What will be output for decimal input 82?
0.82 V
8 V
0.1 V
10 mV

⇒ Maxterm designation for A + B + C is
M₀
M₁
M₃
M₄

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and
90°
60°
45°
30°

⇒ The classes of solid dielectrics are
A, B, C, D, E, F, H
A E B F H C D
Y A E B F H C
A E B F H C