Question is ⇒ A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the, Options are ⇒ (A) R only, (B) C only, (C) L only, (D) R and L combination, (E) , Leave your comments or Download question paper.

Question is ⇒ A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the, Options are ⇒ (A) R only, (B) C only, (C) L only, (D) R and L combination, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the
A.	R only [Wrong Answer]
B.	C only [Correct Answer]
C.	L only [Wrong Answer]
D.	R and L combination [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE

⇒ In indicating instruments the controlling torque is provided by a spring.
TRUE
FALSE

⇒ The function of an AM detector circuit is to
rectify the input signal
discard the carrier
provide audio signal
all of the above

⇒ A parallel ac circuit in resonance will
act like a resistor of low value
have a high impedance
have current in each section equal to the line current
have a high voltage developed across each inductive and capacitive section

⇒ What does the operator ( ) mean in C?
Function expression
Array expression
Structure operator
Increment / Decrement

⇒ A capacitor with initial charge q₀ at t = 0⁺ acts as
current source
voltage source
short-circuit
open-circuit

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ The value of current at resonance in series R-L-C circuit is affected by the value of
C
L
R
all of the above

⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m²
716 m²
7.16 m²
71.6 m²

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is
0.0042
0.0035
0.0025
0.0015

⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage

⇒ Which of the following array names is invalid in Fortran 77?
B(2, 4)
B(M, 3)
B(M, R)
B(3, 6)

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on

⇒ In which region of a CE bipolar transistor is collector current almost constant?
Saturation region
Active region
Breakdown region
Both saturation and active region

⇒ Which of the following statements is written in plain English in 8085?
Data definition
Assignment
Conditional
Repetitive

⇒ The resistance of series field winding is a low resistance.
TRUE
FALSE

⇒ Which of the following element does not have three valence electrons?
Boron
Aluminium
Gallium
Phosphorus

⇒ If f₁ and f₂ and half-power frequency and f₀ be resonant frequency, the selectivity of R-L-C series circuit is given by
(f₂ - f₁)/2f₀
(f₂ - f₁)/f₀
(f₂ - f₀)/(f₁ - f₀)
(f₂ - f₁)/(f₁ - f₀)

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ The PCM signal shown below uses amplitude level of +1 volt and -1 volt to represent binary symbol 0 and 1 respectively. Each code word consists of 4 bits. The sampled version of analog signal from which this PCM signal is derived
EB596
CD231
DA495
25B6A

⇒ A NAND gate has 3 inputs and one output. The number of thyristors required for this gate are
1
2
3
3 or 4

⇒ A dynamometer wattmeter is connected in ac circuit. The reading will be
V-A product
average power
peak power
instantaneous power

⇒ In CE connection, the leakage current of a transistor is about
10 x 10^-9 A
5 x 10^-6 A
200 x 10^-6 A
5 x 10^-3 A

⇒ As compared to 17.34° antenna, the total increase in the signal relayed by 4.5° antenna of INTELSAT-IV is
14.85
220
78
3.85

⇒ A lag compensator
speeds up the transient response of the system
improves steady state behaviour of the system
improves steady state behaviour and speeds up the transient response of the system
improves steady state behaviour and preserves the transient response of the system

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒ The time constant of a series RL circuit is
LR
L/R
R/L
e^-R/L

⇒ In the network of figure, the voltage drops across R₁, R₂, R₃ are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω
8 Ω
5 Ω
3 Ω}

⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as
f
f²
f⁴
f^1/2