Question is ⇒ A D.C. amplifier amplify, Options are ⇒ (A) D.C. only, (B) A.C. only, (C) both A.C. and D.C., (D) none of the above., (E) , Leave your comments or Download question paper.

Question is ⇒ A D.C. amplifier amplify, Options are ⇒ (A) D.C. only, (B) A.C. only, (C) both A.C. and D.C., (D) none of the above., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A D.C. amplifier amplify
A.	D.C. only [Correct Answer]
B.	A.C. only [Wrong Answer]
C.	both A.C. and D.C. [Wrong Answer]
D.	none of the above. [Wrong Answer]
View Answer 6 -16 Explanation:- Answer : A Discuss it below : Abdul Rouf P Said on 2019-03-19 07:16:05 a direct coupled amplifier amplifies both dc and low frequency ac signals Post customs Said on 2018-06-10 11:31:21 Dc amplifiers amplifies DC as well as AC !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ The application of gate signal decreases the break over voltage of on SCR.
TRUE
FALSE

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ A signal x₁(t) and x₂(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric

⇒ The operator precedence in Java is in the order
arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.
increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.
comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.
arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ Which of the following wave remains unaffected during day and night?
Tropospheric wave
Sky wave
Ground wave
None of the above

⇒ While AM has __________ frequencies, FM has __________ number of sidebands.
2, 3
3, 3
3, 5
3, infinite

⇒ In a semi converter feeding a resistive load,
the waveshapes of input voltage and input current are always similar
the waveshapes of input voltage and input current can never be similar
the waveshapes of input voltage and input current are similar only if firing angle is zero
the waveshapes of input voltage and input current are similar only if firing angle is high

⇒ In a class C operation
V_CC is much larger than V_CE(sat)
V_CC is much smaller than V_CE(sat)
V_CC and V_CE(sat) are nearly equal
none of the above

⇒ In a conductor which of the following relations hold good?
∇ x D = r
∇ . D = r
∇ x D = 0
∇ . D = 0

⇒ In a class C power amplifier
resonant frequency of tuned circuit is equal to fundamental frequency of pulsed waveform
resonant frequency of tuned circuit is half the fundamental frequency of pulsed waveform
resonant frequency of tuned circuit has no relation to the fundamental frequency of pulsed waveform
either (b) or (c)

⇒ A speech signal, band limited to 4kHz and peak voltage varying between + 5V and - 5V is sampled at the Nyquist rate. Each sample is quantized and represented by 8 bits. Assuming the signal to be uniformly distributed between its peak values, the signal to noise ratio at the quantizer output is
156 dB
32 dB
48 dB
64 dB

⇒ The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave
0.33
0.5
2
1

⇒ A major advantage of TWT over a Klystron lies in its
higher bandwidth
higher gain
higher frequency
higher output

⇒ The fabrication of microstrip line is done by
photo etching
printed circuit technique
oxidation
cladding

⇒ When a vector has positive divergence, it indicates that the vector quantity has at that point and if the divergence is negative, it indicates __________ .
source, sink
sink, source
positive value, negative value
negative value, positive value

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ In force voltage analogy the quantity analogous to spring constant K is
R
C
L
1/C

⇒ The resistance of the circuit shown is figur
5 Ω
More than 6 Ω
More than 4 Ω
Between 6 and 7 Ω

⇒ The power to the portable unit of a cordless telephone is provided by
pencil cells
dry cells
rechargeable cells
AC mains

⇒ Two identical NMOS transistors M₁ and M₂ are connected as shown below. V_bias is chosen so that both transistors are in saturation. The equivalent g_m of the pair is defined t
the sum of individual g_m's of the transistors
the product of individual g_m's of the transistors
nearly equal to the g_m of M₁
nearly equal to g_m / g₀ of M₂

⇒ In a line with finite attenuation
power transmission is least efficient when there are no standing waves on the line
power transmission is most efficient when there are no standing waves on line
Load power depends on phase constant
standing waves will always exist on the line

⇒ In a T flip-flop the output frequency is
same as input frequency
half of I/p frequency
double the input frequency
none

⇒ In auxiliary commutated chopper, the charging and discharging time of capacitor
are constant
depend on load current
may be constant or may depend on load current
none of the above

⇒ Loss of charge method is suitable for medium resistances.
TRUE
FALSE

⇒ In an R-L-C series circuit, R = 2/L/C . If R is doubled
the response will become underdamped
the response will become overdamped
the response will be critically damped
the response may be under damped or overdamped

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
L X I rp, data 16
MOV M, r
MVIM, data
ADC M

⇒ In disc mounting of SCR
SCR is clamped on one side of disc shaped heat sink
SCR is clamped between two disc shaped heat sinks
The SCR has low current rating
None of the above

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω