Question is ⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to, Options are ⇒ (A) increase its IQL, (B) reduce its I0H, (C) increase its speed of operation, (D) reduce power dissipation, (E) , Leave your comments or Download question paper.

Question is ⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to, Options are ⇒ (A) increase its IQL, (B) reduce its I0H, (C) increase its speed of operation, (D) reduce power dissipation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to
A.	increase its I_QL [Wrong Answer]
B.	reduce its I_0H [Wrong Answer]
C.	increase its speed of operation [Correct Answer]
D.	reduce power dissipation [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ADI A4H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): In many materials, dielectric polarization causes mechanical distortion.

Reason (R): If dielectric polarization causes mechanical distortion then mechanical distortion must cause dielectric polarization.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A linear system is characterized by H(ω) = Be^-2ω² the system is physically
unrealizable
realizable
depends upon B
depends upon constant 2

⇒

Match the following:

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used

A-4, B-1, C-3, D-2
A-3, B-4, C-1, D-2
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1

⇒

Assertion (A): Diamond and carborudum are both very hard materials.

Reason (R): Valence band can be extremely strong.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): An on off controller gives rise to oscillation of the output between two limits.

Reason (R): Location of a pair of poles on jω axis gives rise to self sustained oscillations in the output.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In an idealized half wave rectified system the average and r.m.s. values of voltage are __________ respectively.
2V_m/p, V_m/2
V_m/p, V_m/2
V_m/p, V_m/2
V_m.p, V_m/2

⇒ If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is
1 ohms
10 ohms
25 ohms
100 ohms

⇒ The number of doped regions in a SCR is
2
3
4
5

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒ A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is
I
0
less than I
0.5

⇒ An electric heater is controlled by thyristors through on-off control. If a = 0.4, the heating is
16% maximum
40% of maximum
60% of maximum
84% of maximum

⇒ At very low frequencies a series R-C circuit behaves as almost purely __________ .
resistive
inductive
capacitive
none of the above

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. In receivers operating upto the limit of shortwave broadcasting the local oscillator often used is
Armstrong oscillator
Colpitts oscillator
Clapp oscillator
Ultra Audio oscillator

⇒ A balanced modulator is used in the generation of which of the following?
DSB-SC signal
FM signal
PM signal
PAM signal

⇒ Tropospheric mode of propagation is used in
UHF
VLF
MF
HF

⇒ The voltage of single phase supply to residential consumers in India is
400 V
230 V
2.2 kV
11 kV

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ In practical commercial FM system, channel bandwidth is
150 kHz
100 kHz
88 MHz
108 MHz

⇒ In common base amplifier the current gain is less than one, but the voltage gain may be anywhere from
0.5 to 1
1 to 5
5 to 10
50 to 2000

⇒

Match the following:

	List I		List II
A.	Servomotor	1.	Error detector
B.	Amplidyne	2.	Transducer
C.	Potentiometer	3.	Actuator
D.	Flapper valve	4.	Power amplifier

A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ The frequency deviation of a FM signal produced from PM is
identical to that of FM signal produced by direct method
larger than that of a FM signal produced by direct method
directly proportional to the peak amplitude and the frequency of modulating signal
directly proportional to the peak amplitude of the modulating signal

⇒ In the epitaxial diffused method of fabricating integrating circuits the process involved are __________

Epitaxial growth
Diffusion
Silicon diode growth
Vacuum evaporation of aluminium
Photoetching

The correct order is
1 - 2 - 3 - 4 - 5
1 - 3 - 5 - 2 - 4
3 - 1 - 4 - 5 - 2
1 - 3 - 2 - 4 - 5

⇒ In a AM wave the carrier and one of the side bands is suppressed. If m = 0.5, the percentage saving in power is
0.5
0.833
0.944
1

⇒ Consider the following expression for the driving point imped
2 and 4
1 and 3
1 and 4
2 and 3

⇒ The inductance of a twin feeder used to connect antenna to TV receiver is about
0.2 μ H/m
0.6 μ H/m
1.6 μ H/m
10 μ H/m

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop