Question is ⇒ A counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time, Options are ⇒ (A) 8 μ sec, (B) 10 μ sec, (C) 2 μ sec, (D) 5 μ sec, (E) , Leave your comments or Download question paper.

Question is ⇒ A counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time, Options are ⇒ (A) 8 μ sec, (B) 10 μ sec, (C) 2 μ sec, (D) 5 μ sec, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
A.	8 μ sec [Correct Answer]
B.	10 μ sec [Wrong Answer]
C.	2 μ sec [Wrong Answer]
D.	5 μ sec [Wrong Answer]
View Answer 3 -10 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ The antenna diameter of a radar system is doubled. The maximum range will
be doubled
become four times
be halved
decrease to one fourth

⇒ In low power factor wattmeter, the compensating coil is connected
in series with current coil
in parallel with current coil
in series with pressure coil
in parallel with pressure coil

⇒ Two linearly polarized plane waves A and B travelling in free space in the positive x direction meet at a point. Wave A is polarized in the y direction and the wave B is polarized in the z direction. If the two waves are of equal amplitude and are in phase quadrature, the resultant wave will be
circularly polarized
elliptically polarized
linearly polarized
vertically polarized

⇒ Which of the following statements is not true in regard to storage time of a diode?
During this time, the diode is reverse-biased
The diode conducts during this time
It is due to the time taken by carriers to depart from the function when the diode is reverse-biased
During this time the diode current is zero

⇒ The output of a full adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ In a synchro transmitter, which coil acts as primary?
Rotor
Stator
Partly rotor and partly stator
Tertiary

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ In 8085 microprocessor, what is the length of A-register?
6 bits
8 bits
12 bits
16 bits

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒ McMurrary full bridge inverter uses
auxiliary commutation
complementary commutation
natural commutation
any of the above

⇒ The expression A² + B² - 3 AB when written is Pascal should be written as
A * A + B * B - 3 A * B
A * A + B * B - 3.0 A * B
A * A + B * B - 3.0 * A * B
A * A + B * A - 3 * A * B

⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒

Assertion (A): As per Miller theorem a capacitance C from input to output appears as a much larger capacitance across input terminals

Reason (R): In a lag network the output voltage appears across capacitor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease

Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒

Match the following:

	List I		List II
A.	R = 0	1.	Undamped oscillation
B.	R < 2 L/C	2.	Damped oscillation
C.	R = 2 L/C	3.	Critically damped response
D.	R > 2 L/C	4.	Non-oscillatory response.

A-1, B-2, C-3, D-4
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4
A-3, B-4, C-1, D-2

⇒ If x = 0.1396 radians, the values of 1 - cos x and 2 sin² (x / 2) using floating point arithmetic with a 4 digit mantissa are respectively
.1000 E - 1 each
.9727 E - 2 each
.1000 E - 1 and .9727 E - 2 respectively
.9727 E - 2 and .1000 E - 1 respectively

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒ Serial input data of 8085 can be loaded into bit-7 of the accumulator by
executing a RIM instruction
executing RSTI
using TRAP
none of the above

⇒

Assertion (A): When p-n junction is forward biased, steady current flows.

Reason (R): When a p-n junction is forward biased, free electrons cross the junction from n to p and holes from p to n.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The correct sequence of subsystems in an FM receiver is
Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier
RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier
RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier
Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator

⇒ The logic circuit in the given figure realizes the func
(A + B + C) (D E)
(A + B + C) (D E)
(A + B + C) (D E)
(A + B + C) (D E)

⇒ In a loss-free R-L-C circuit the transient current is
oscillating
square wave
sinusoidal
non-oscillating

⇒ The unit for mmf is
A
Wb
T
V

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider the following DO statement in Fortran 77 10
2
5
zero

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true