Question is ⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be, Options are ⇒ (A) 6, (B) 12, (C) 720, (D) 1040, (E) , Leave your comments or Download question paper.

Question is ⇒ A computer program is used to read N and compute N !. IF N = 6, the result will be, Options are ⇒ (A) 6, (B) 12, (C) 720, (D) 1040, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A computer program is used to read N and compute N !. IF N = 6, the result will be
A.	6 [Wrong Answer]
B.	12 [Wrong Answer]
C.	720 [Correct Answer]
D.	1040 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following does not show non-linear V-I characteristics?
Schottky diode
Tunnel diode
Thermister, at a fixed temperature
p-n junction diode

⇒

Match the following:

	List I		List II
A.	DMA controller	1.	Interface between computer and video display adapter
B.	CKT controller	2.	Used to read data directly from disk into directly memory
C.	Interrupt controller	3.	Supervises the operation of control signal

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-2, B-1, C-3

⇒

Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of the following represents the equivalent circuit of a crystal for crystal oscilla
Figure A
Figure B
Figure C
None of the above

⇒ For infinite value of SWR on a transmission line, the line be terminated with impedance as
an open-circuit
a short-circuit
a pure resistance
all of the above

⇒ A typical value of g_m for a FET is about 25 μs.
TRUE
FALSE

⇒ Thermal runaway is not possible in FET, because as the temperature of FET increases.
the mobility decreases
the transconductance increases
impedance of the source
power dissipation in the chip

⇒ What is the characteristic of a good control system?
Sensitive to parameter variation
Insensitive to input command
Neither sensitive to parameter variation nor sensitive to input commands
Insensitive to parameter variation but sensitive to input commands

⇒ Fourier transform of signal obtained after taking difference between step function and its reverse version is given as __________ .
2jω
2/jω
4/jω
4jω

⇒ Which of the following capabilities are available in a Universal Shift Register?

Shift left
Shift right
Parallel load
Serial add

Select the correct answer from the codes given below:
2 and 4 only
1, 2 and 3
1, 2 and 4
1, 3 and 4

⇒ In a horizontal polarized wave
magnetic field is perpendicular to ground
magnetic field component is parallel to ground
electric field component is perpendicular to ground
electric field is parallel to ground

⇒ Low-orbit satellites are not used for communications because they
produce sonic booms
do not provide 24 hour/ day contact to the users on Earth
heat up and melt
none

⇒ A series RLC circuit is at resonance at 200 Hz. If capacitance is increased to four times, the circuit will be in resonance at
200 Hz
400 Hz
100 Hz
800 Hz

⇒ Which of the following form of angle modulation in this? If e = 10 sin(10⁸ t + 3 sin 10⁴ t)
AM
FM
AM or FM
AM or PCM

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 10 times that on the moon.
1.73 TC
17.3 GC
17.3 TC
1.73 GC

⇒ If 4 quadrant operation is required we need
dual converter
full converter
semi converter
none of the above

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that
a double pole is present
a pair of complex conjugate poles is present
either (a) or (b)
neither (a) nor (b)

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒ In the circuit of figure, the waveshape of load current when thyristor conducting
constant
increasing exponentially
decreasing exponentially
either (b) or (c)

⇒ The realization of the term Ks yields
a resistance of value K ohms
a capacitances of value K farads
an inductance of value k farads
either (b) or (c)

⇒ Ferrimagnetic materials have anti-parallel orientation of equal moments of permanent dipoles.
TRUE
FALSE

⇒ A moving iron instrument has
two iron vanes, one fixed and one movable
two movable iron vanes
two aluminium vanes, one fixed and one movable
two vanes, one fixed made of Aluminium and the other movable made of iron

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637

⇒ 8255 A has three 8 bit ports A, B, C for peripheral data transfer. For programming 8255 A, these ports are grouped as
Port A with Port B
Port A with 4 most significant ports of C, port B with 4 least significant ports of C
Port A with Port C
none of the above

⇒ Which of the following has highest power gain?
CE
CC
CB
CB or CC

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ Given I_s = 20 A, V_s = 20 V, the current I in the 3 Ω resistance is give
0.166666666666667
0.333333333333333
0.0833333333333333
16 A

⇒ In a JFET, gates are always
forward biased
reverse biased
either forward or reverse biased
unbiased