Question is ⇒ A communication receiver is, Options are ⇒ (A) TRF receiver, (B) a superheterodyne receiver, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper.

Question is ⇒ A communication receiver is, Options are ⇒ (A) TRF receiver, (B) a superheterodyne receiver, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A communication receiver is
A.	TRF receiver [Wrong Answer]
B.	a superheterodyne receiver [Correct Answer]
C.	either (a) or (b) [Wrong Answer]
D.	neither (a) nor (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ In a 3 phase semiconverter, the dc output voltage for a certain firing angle is 50% of the maximum possible value. The firing angle is
30°
60°
90°
120°

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ A pulse function having magnitude E and duration from t = 0 to t = a can be represented as
sum of two pulse functions
difference of two pulse functions
difference of two step functions each of magnitude E and one originating at t = 0 and the other at t = a
none of the above

⇒ An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
180
120
90
60

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation of FM
preamplifying the whole audio band
amplifying the higher audio frequencies
boosting the pass frequencies

⇒ One input terminal of high gain comparator circuit is connected to ground and a sinusoidal voltage is applied to the other input. The output of comparator will be
sinusoidal
full rectified sinusoidal
half rectified sinusoidal
square wave

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ If a microcomputer has a 64 K memory; what is the hexadecimal notations for the last memory location?
1111
1A1A
EEEF
FFFF

⇒ Which of the following output configurations are available in a TTL gate?

Open collector output
Totem pole output
Tristate output

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ A + AB =
A
A
A + B
A + B

⇒ A single phase series converter is used for
high voltage output
high current output
high voltage and high current output
improving the circuit efficiency

⇒ In atomic physics, a state with l = 0 is called p state.
TRUE
FALSE

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ In 8085 microprocessor, what is the length of A-register?
6 bits
8 bits
12 bits
16 bits

⇒ Velocity of the wave when it passes from air into sphere
decreases
increases
same
no change

⇒ A message signal with bandwidth 10 kHz is lower sideband SSB modulated with carrier frequency f_c1 = 10⁶ Hz. The resulting signal is then passed though a narrow band frequency modulator with carrier frequency f_c2 = 10⁹ Hz. The bandwidth of the output would be
4 x 10⁴ Hz
2 x 10⁶ Hz
2 x 10⁹ Hz
2 x 10¹⁰ Hz

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ VSWR = E_max/E_min.
TRUE
FALSE

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed

⇒ In case of surface waves the field strength at a point is directly proportional to
antenna height
wave frequency
current of the antenna
distance of the point from the antenna

⇒ A casual LTI system is described by the difference equat
|a| = 2 |β| < 2
|a| > 2 |β| > 2
|a| < 2 any value of β
|β| < 2, any value of a

⇒ Derivative control action is effective?
Only during steady state periods
Only during transient state periods
During both steady state and transient state periods
Either during steady state or during transient state periods

⇒ Ac signals are given to both inverting and non-inverting terminals of an op-amp. When will the output maximum
when the phase difference between the inputs is 0°
when the phase difference between the inputs in 90°
when the phase difference between the inputs is 180°
when the phase difference between the inputs is 0 or 180°

⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative

⇒ The gauge factor of a semiconductor strain gauge is about
2
10
100
1000

⇒ A higher value of Standing Wave Ratio indicates
least mismatch between line and load
greater mismatch between load and line
number of nodes is equal to the number of antinodes
none of the above