Question is ⇒ A Colpitt's oscillator uses, Options are ⇒ (A) a tapped inductor, (B) an inductor and two capacitors, (C) both (a) and (b), (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ A Colpitt's oscillator uses, Options are ⇒ (A) a tapped inductor, (B) an inductor and two capacitors, (C) both (a) and (b), (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Colpitt's oscillator uses
A.	a tapped inductor [Wrong Answer]
B.	an inductor and two capacitors [Wrong Answer]
C.	both (a) and (b) [Correct Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Resistivity of carbon is around
10 to 70 m-ohm-cm
80 to 130 m-ohm-cm
800 to 1300 m-ohm-cm
8000 to 13000 m-ohm-cm

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ The two terms used to describe performance of a directional coupler are
coupling and directivity
gain and coupling
gain and directivity
gain and isolation

⇒ A geostationary satellite
is located at a height of 358, 00 km
appears stationary over earth's magnetic pole
is motionless in space but keeps spinning
orbits the earth within a 24 hour period

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒ Half power point directions for broadside is
60°
30°
45°
at any angle

⇒ In figure as the load resistance is cha
the zener current remain constant
the load current remains constant
the output voltage remains constant
the output voltage and current through R remain constant

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): Industrial robots improve productivity.

Reason (R): Robots can handle monotonous and complex jobs without error in operation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a single phase full wave ac regulator the firing angles during both half cycles are equal.
TRUE
FALSE

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ Which variety of copper has the best conductivity?
Pure annealed copper
Hard drawn copper
Induction hardened copper
Copper containing traces of silicon

⇒ A cycloconverter cannot give a frequency higher than input frequency.
TRUE
FALSE

⇒ In a linear bilateral passive element two port which of the following holds for z parameters?
z₁₁ = z₂₂
z₁₂ z₂₂ = z₁₁ z₂₂
z₁₁ z₁₂ = z₂₂ z₂₁
z₁₂ = z₂₁

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ A real number consists of
integer part
integer part and fraction part
integer part, fraction part along with positive or negative sign
none of the above

⇒ In 8156, the lower times byte is addressed with 24 H, and the upper times byte with
20 H
23 H
24 H
25 H

⇒ In drawing phasor diagram
rms values are used
peak values are used
either rms or peak values are used
either rms or peak or averages values are used

⇒ Current chopping leads to
over voltage
over current
both over voltage and over current
either over voltage or over current

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I (Types of N-bit ADC)		List II (Characteristics)
A.	Flash converter	1.	Integrating Type
B.	Successive	2.	Fastest converter approximation
C.	Counter ramp	3.	Maximum conversion time = N bits
D.	Dual slow	4.	Used a DAC in its feedback path

A-2, B-3, C-4, D-1
A-1, B-3, C-4, D-2
A-2, B-4, C-3, D-1
A-1, B-4, C-3, D-2

⇒ In a radar, the return echo arrives after the allocated pulse interval. Then
the receiver may be over loaded
the target will appear closer than its actual position
the return echo may interfere with transmitter operation
none of the above

⇒ If a linear time invartant system is exicited by a pure random signal like white noise, the output of the linear system will have which of the following properties?
Output will be a white noise
Output will be periodic
Output will be random
Output will be correlated or coloured noise

⇒ If a line is terminated in characteristic impedance Z₀, the input impedance measured at the input will be
Z₀
Z₀/2
Zero
infinite

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒

Assertion (A): Two transistors one n-p-n and the other p-n-p are identical in all respects (doping, construction, shape, size). The n-p-n transistor will have better frequency response.

Reason (R): The electron mobility is higher than hole mobility.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following microphones works on the piezoelectric effect?
Carbon
Condenser
Moving coil
Crystal