Question is ⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be, Options are ⇒ (A) 5 ∠19° A, (B) 10 ∠19° A, (C) 10 ∠38° A, (D) 10 ∠9.5° A, (E) , Leave your comments or Download question paper.

Question is ⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be, Options are ⇒ (A) 5 ∠19° A, (B) 10 ∠19° A, (C) 10 ∠38° A, (D) 10 ∠9.5° A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
A.	5 ∠19° A [Wrong Answer]
B.	10 ∠19° A [Correct Answer]
C.	10 ∠38° A [Wrong Answer]
D.	10 ∠9.5° A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The magnitude plot of a composite signal x(t) = e^2jt + e^3jt is
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ To produce magnetic flux, mmf is necessary.
TRUE
FALSE

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ Which of the following waves do not exist in waveguides?
TE waves
TM waves
TE and TM waves
TEM waves

⇒ Which one of the following is a passive device/Component?
Transformer
Oscillator
Generator
None

⇒ In a transistor, current I_CBO flow when
some D.C. voltage is applied in the reverse direction to the emitter junction with the collector open circuit
some D.C. voltage is applied in the forward direction to the collector junction with the emitter open circuit
some D.C. voltage is applied in the reverse direction to the collector junction with the emitter open circuited
some D.C. voltage is applied in the forward direction to the emitter junction with the collector open circuited

⇒ It two voltages are v₁ = 100 sin (ωt - 30°) and v₂ = cos ω t then
v₁ is leading v₂ by 30°
v₂ is leading v₁ by 30°
v₂ is leading v₁ by 60°
v₁ is leading v₂ by 60°

⇒ A semiconductor Read-only-Memory basically is
a combinational logic circuit
a set of flip-flop memory elements
a sequential circuit with flip-flops and gates
none of the above

⇒

Assertion (A): When light falls at junction of p-n photodiode, its p side becomes positive and n side becomes negative.

Reason (R): When a photodiode is short circuited, the current in the external circuit flows from p side to n side.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Separation property of state-transition matrix is
φ(t - t₀) = φ(t) φ(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)
φ(t - t₀) = φ(t) φ^-1(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)

⇒ A higher value of Standing Wave Ratio indicates
least mismatch between line and load
greater mismatch between load and line
number of nodes is equal to the number of antinodes
none of the above

⇒ Which memory has read operation, byte erase, byte write and chip erase?
RAM
UVEPROM
EEPROM
both (b) and (c)

⇒ Consider a loss less antenna with a directive gain of + 6 dB. If 1 mW of power is fed to it the total power radiated by the antenna will be
4 mW
1 mW
7 mW
1/4 mW

⇒ For a push pull circuit the most favoured biasing method is
self bias
emitter bias
diode bias
collector bias

⇒ A single mode fibre not suffer from which type of dispersion?
Waveguide dispersion
Material dispersion
Intermodal dispersion
Polarization mode dispersion

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ MTI stands for
Moving Target Indicator
Microprocessor Tracking Index
Multiplexed Telemetry Index
Maximum Transmission Index

⇒ In 8085, the instruction CMA is an example of
Implict addressing
Direct addressing
Register addressing
Immediate addressing

⇒

Assertion (A): EM waves are attenuated as they travel outward from a source

Reason (R): Both field intensity and power density follow inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the follo
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ Some types of traps used in video IF amplifier of colour TV are
shunt traps
series traps
absorption traps
all of the above

⇒ The circuit shown in figure will ac
differentiator
adder
clipper
clamper

⇒ The number of doped regions in a SCR is
2
3
4
5

⇒ For a P-N junction diode, the current in reverse bias may be
few amperes
between 0.5 A and 1 A
few milliamperes
few micro or nanoamperes

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

⇒ Read the following statements about address space in microprocessors

An address space is a set of all possible addresses which can be generated by a microprocessor.
Each address in the address space allows a designer to provide at least one memory or I/O location in the system.
Two types of address spaces are memory and I/O address space.
Some micro processors have only one type of address space.

Which of the above are correct?
All
1, 2, 3 only
1, 2, 4 only
1, 3, 4 only

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300