Question is ⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR, Options are ⇒ (A) decreases, (B) increases, (C) remains same, (D) partially affected, (E) , Leave your comments or Download question paper.

Question is ⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR, Options are ⇒ (A) decreases, (B) increases, (C) remains same, (D) partially affected, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
A.	decreases [Wrong Answer]
B.	increases [Correct Answer]
C.	remains same [Wrong Answer]
D.	partially affected [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ The dc output voltage from a power supply
increases with higher values of filter capacitance and decreases with more load current
decreases with higher values of filter capacitance and increases with more load current
decreases with higher values of filter capacitance as well as with more load current
increases with higher values of filter capacitance as well as with more load current

⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above

⇒ Kirchoff's voltage law is not valid for a non-linear network
the statement is true
the statement is false
can't say
none of the above

⇒ In a single phase cycloconverter with centre tapped transformer
all thyristors carry currents for equal duration
the durations of currents in all thyristors may or may not be equal
the durations of currents in all thyristors cannot be equal
the duration of currents in all thyristors must be equal for satisfactory operation

⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D

⇒ Status register in the 8156 is read with
IN 20 H
OUT 20 H
either (a) or (b)
none of the above

⇒ An ammeter is
secondary instrument
absolute instrument
recording instrument
integrating instrument

⇒ A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be
0.25 Ω
0.5 Ω
1.25 Ω
2.5 Ω

⇒ IC 74181 has two select lines.
TRUE
FALSE

⇒

Assertion (A): A PROM is a user programmable ROM.

Reason (R): After programming PROM behaves like ROM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For resonant long wire antenna 'n' half wavelength long in free space, if 'n' is increased then inclination of the major lobe with wire axis will __________ .
increases
decreases
remains same
none

⇒ MS outlook is a software for DTP.
TRUE
FALSE

⇒ Read the following statements about TWT

It uses thermionic emission.
It uses an attenuater.
It is inherently a resonant device.
It has broad bandwidth.

Which of the above are correct?
1, 2, 3 and 4
1, 2 and 3
1, 3 and 4
1, 2 and 4

⇒ A cycloconverter uses
natural commutation
forced commutation
either natural or forced commutation
both natural and forced commutation together

⇒ A 3 phase star-connected load has one capacitor C in R phase and two equal resistances in Y and B phases.The phase sequence is RBY. Then
V_B0 > V_Y0
V_B0 < V_Y0
V_B0 = V_Y0
V_B0 = V_BY

⇒ Which of the following statement is incorrect?
Z₀ is an ac characteristic that is the same for any length of time
The characteristic impedance can be measured approximately with a sensitive ohm meter
A line terminated in its Z₀ is a flat or non-resonant line
A twin lead has higher Z₀ but lower losses than coaxial cable

⇒ The resistance of series field winding is a low resistance.
TRUE
FALSE

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ A TV receiver is 40 cm wide and 30 cm high. The EHT supply required is about
2kV
20 kV
53 kV
10 W

⇒ In a junction transistor, the collector cut-off current 'I_CB0' reduces considerably by doping the
emitter with high level of impurity
emitter with low level of impurity
collector with high level of impurity
collector with low level of impurity

⇒ The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately
47 μm
33 μm
92 μm
1.22 μm

⇒ The polar plot of G(jω) = 1/jω is
positive imaginary axis
positive real axis
negative imaginary axis
negative real axis

⇒

Assertion (A): In a differential amplifier the current through common emitter resistor is called tail current

Reason (R): CMRR of an op-amp indicates how a differential signal amplified

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
0.001
0.005
0.01
0.02

⇒ Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?
Voltmeter having a resistance of 5 kΩ
Voltmeter having a sensitivity of 1 kW/V
Voltmeter having sensitivity of 10 kW/V
None of the above

⇒ Microwaves
get reflected by ionosphere
are absorbed by ionosphere
are neither reflected nor absorbed by ionosphere
are both reflected and absorbed by ionosphere

⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
1.9 k bits/sec
0.95 k bits/sec
3.8 k bits/sec
7.6 k bits/sec