Question is ⇒ A cavity resonator is, Options are ⇒ (A) a hollow metallic enclosure, (B) a hollow enclosure having magnetic material as its walls, (C) a hollow enclosure having dielectric material as its walls, (D) either (b) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ A cavity resonator is, Options are ⇒ (A) a hollow metallic enclosure, (B) a hollow enclosure having magnetic material as its walls, (C) a hollow enclosure having dielectric material as its walls, (D) either (b) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A cavity resonator is
A.	a hollow metallic enclosure [Correct Answer]
B.	a hollow enclosure having magnetic material as its walls [Wrong Answer]
C.	a hollow enclosure having dielectric material as its walls [Wrong Answer]
D.	either (b) or (c) [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A Karnaugh map with 4 variables has
2 cells
4 cells
8 cells
16 cells

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒ The purpose of using negative feedback in a op-amps is to
stabilize overall gain
increase output
stabilize overall gain and increase output
increase output and decrease input

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ Coaxial cables can be used for which frequency?
15 kHz
10 MHz
200 MHz
2000 MHz

⇒ The poles and zeros of a positive real functions are real or occur in conjugate pair.
TRUE
FALSE

⇒ A reflex klystron oscillator uses
one cavity resonator
two cavity resonators
three cavity resonators
none of the above

⇒ In shot noise
the current rises around mean value
the current rises to peak value, decreases to zero and then again rises
the current may become negative
the current is always less than the mean value

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ The drift velocity of electrons is
very small as compared to speed of light
equal to speed of light
almost equal to speed of light
half the speed of light

⇒ Which are of the following oscillators is well suited for the generation of wide range audio-frequency sine waves?
RC phase-shift oscillator
Wien-bridge oscillator
Colpitts oscillator
Hartley oscillator

⇒ Thermal run away of a transistor occurs when
heat dissipation from transistor is excessive
transistor joints melt due to high temperature
there is excessive leakage current due to temperature rise
none of the above

⇒ The response shown in figur
over damped
critically damped
under damped
either (a) or (c)

⇒ For transmission line load matching over a range of frequencies, it is best to use a
double stub
balun
single stub of adjustable position
broadband directional coupler

⇒ A thermometer requires 1 minute to indicate 98% of its final response to a step input. If it is a first order system the time constant is
1 minute
0.5 minute
0.25 minute
0.1 minute

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A thermal power plant has an efficiency of 0.4. If 0.6 kg of coal is burnt to generate 1 kWh, the calorific value of coal is
about 3500 kcal/kg
about 2500 kcal/kg
about 1500 kcal/kg
about 7500 kcal/kg

⇒ In an electrochemical process the mass of material deposited at an electrode is proportional to
time for which current is passed
magnitude of current
electric charge through the electrolyte
none of the above

⇒

Assertion (A): Relative permittivity is determined by the atomic structure of the material.

Reason (R): Absolute permittivity is determined by the atomic structure of the material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ In sign magnitude numbers,
the leading bit stands for the sign
the leading bit is part of the magnitude
the leading bit is always 0
the leading bit is always 1

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ Which of the following input is not possible in case of a SR flip-flop?
S = 0, R = 0
S = 0, R = 1
S = 1, R = 0
S = 1, R = 1

⇒ The output Y of the circuit shown in the figur
(A + B) C + DE
AB + C(D + E)
(A + B) C + D + E
(AB + C) . DE

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ For a reactance function H(s)
Re [H(jω)] is positive for ω ≥ 0
Re [H(jω)] is zero for ω ≥ 0
Re [H(jω)] is positive or zero for ω ≥ 0
Re [H(jω)] is zero or negative for ω ≥ 0

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V