Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A capacitor is generally a |

A. | bilateral and active component [Wrong Answer] |

B. | active, passive, linear and nonlinear component [Wrong Answer] |

C. | linear and bilateral component [Correct Answer] |

D. | non-linear and active component [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The number of possible ordered trees with 3 nodes A, B, C is

6

8

10

12

⇒ For a two-port symmetrical bilateral network, if A = 3 and B = 1 ω, the value of parameter C will be

4 s

6 s

8 s

16 s

⇒ Kirchhoff's law is not applicable to circuits with

lumped parameters

passive elements

distributed parameters

non-linear resistances

⇒ The circuit having same properties in either direction is known as____circuit.

bilateral

unilateral

irreversible

reversible

⇒ For a linear network containing generators and impedances, the ratio of the voltage to the current produced in other loop is the same as the ratio of voltage and current obtained if the positions of the voltage source and the ammeter measuring the cuiTent are interchanged. The network theorem is known as

Millman's theorem.

Norton's theorem.

Tellegen's theorem.

Reciprocity theorem.

⇒ Nodal analysis is based on

KCL.

KVL.

both.

law of conservation of energy.

⇒ Which of the following is linear and bilateral parameter ?

resistors

semi-conductor diodes

electron tubes

transistor

⇒ Which of the following is not a nonlinear element?

Gas diode

Heater coil

Tunnel diode

Electric arc

⇒ A linear resistor having 0 < R < ∞ is a

current controlled resistor

voltage controlled resistor

both current controlled and voltage controlled resistor

none of the above

⇒ The terminals across the source are____ if a current source is to be neglected.

open circuited

short circuited

replaced by a capacitor

replaced by a source resistance

⇒ The circuit whose properties are same in either direction is known as

unilateral circuit

bilateral circuit

irreversible circuit

reversible circuit

⇒ The concept on which Superposition theorem is based is

reciprocity

duality

non-linearity

linearity

⇒ Thevenin resistance R

_{th}is found

by removing voltage sources along with their internal resistances

by short-circuiting the given two terminals

between any two 'open' terminals

between same open terminals as for E

_{th}

⇒ Which of the following is an active element in a circuit?

Current source

Resistance.

Inductance.

Capacitance.

⇒ Superposition theorem is not applicable for

voltage calculations

bilateral elements

power calculations.

passive elements

⇒ A constant current source supplies a current of 300 mA to a load of 1 kω. When the load is changed to 100 ω, the load current will be

3 A

300 mA

30 mA

100 mA

⇒ Pole of a network is a frequency at which

network function becomes zero.

network function becomes infinite.

network function becomes unity.

none of these.

⇒ A network which contains one or more than one source of e.m.f. is known as

linear network

non-linear network

passive network

active network

⇒ The first and last critical frequency of an RC-driving point impedance function must respectively be

a zero and a pole

a zero and a zero

a pole and a pole

a pole and a zero

⇒ To neglect a voltage source, the terminals across the source are

open-circuited.

short-circuited.

replaced by some resistance.

replaced by inductor.

⇒ A circuit having neither any energy source nor emf source is called the____ circuit.

unilateral

bilateral

passive

active

⇒ In a delta network each element has value R. The value of each element in equivalent star network will be

R/6

R/4

R/2

R/3

⇒ A network has 10 nodes and 17 branches. The number of d iferent node pair voltage would be

7

9

45

10

⇒ Kirchhoff's current law states that

net current flow at the junction is positive

algebraic sum of the currents meeting at the junction is zero

no current can leave the junction without some current entering it.

total sum of currents meeting at the junction is zero

⇒ Kirchhoff' s laws are valid for

linear circuits only.

passive time invariant circuits.

nonlinear circuits only.

both linear and nonlinear circuits

⇒ Kirchhoff's laws are not applicable to circuits with

distributed parameters.

Jumped parameters

passive elements

nonlinear resistances

⇒ The theorem that enables a number of voltage (or cuiTent) sources to be combined directly into a single voltage (or current) source is the____ theorem.

compensation

reciprocity

Millman's

Maxwell's

⇒ The superposition theorem is applicable to

voltage only

current only

both current and voltage

current voltage and power

⇒ If a circuit does not contain any source of energy or e.m.f. it is known as

unilateral circuit

bilateral circuit

passive network

active network

⇒ While determining R

_{TH}of a circuit

voltage and current sources should be left as they are.

all sources should be replaced by their source resistances.

all independent current and voltage sources are shortcircuited

none of the above