Question is ⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth, Options are ⇒ (A) 4°, (B) 2°, (C) 10°, (D) 15°, (E) , Leave your comments or Download question paper.

Question is ⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth, Options are ⇒ (A) 4°, (B) 2°, (C) 10°, (D) 15°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth
A.	4° [Wrong Answer]
B.	2° [Correct Answer]
C.	10° [Wrong Answer]
D.	15° [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Bandwidth of a TV signal is 5 MHz.

Reason (R): TV systems use vestigial side band transmission.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Incompatibility between memory and I/O device may be due to
timing according to which data transfer is to take place
electrical characteristics of the two devices
format of data transfer
all of the above

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒ In the given figure forward current wave has a magnitud
0.45 A
0.3 A
0.2 A
0.1 A

⇒ In sign magnitude numbers,
the leading bit stands for the sign
the leading bit is part of the magnitude
the leading bit is always 0
the leading bit is always 1

⇒

Assertion (A): Most of magnetic circuits have an air gap.

Reason (R): An air gap has high reluctance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Serial input data of 8085 can be loaded into bit-7 of the accumulator by
executing a RIM instruction
executing RSTI
using TRAP
none of the above

⇒

Assertion (A): In n-p-n transistor conduction is mainly due to electrons.

Reason (R): In n type materials electrons are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ To make antenna more directional, either its size must be increased or
the number of its feed horns must be increased
the frequency of its transmission must be increased
its effective isotropic radiated power (EIRP) must be increased
its footprint must be increased

⇒ In high power radars, which of the following are used for switching?
Power diode
Power BJT
Power MOSFET
Thyristor

⇒ Maximum power transfer theorem finds application in
power circuits
distribution circuits
communication circuits
both power and communication circuits

⇒ Audio amplifiers need
Bass control
Treble control
Both Bass and Treble control
Either Bass or Treble control

⇒ Tape recorders use
cone type loudspeakers
horn type loudspeakers
either cone type or horn type loudspeakers
none of the above

⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ
0.99 V
0.9 V
0.1 V
0

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ Z flag is reset if an ALU operation results in 0.
TRUE
FALSE

⇒ If the inputs to a 3 bit binary adder are 111₂ and 111₂, the output will be 110₂
TRUE
FALSE

⇒ A number given in binary as 0101.01 is to be scaled up 4 times. The scaled up binary is
10101
1.0101
404.04
10.101

⇒ A zinc carbon cell is a primary cell.
TRUE
FALSE

⇒ A function is given f(t) = sin²t + cos²t. Which of the following is true?
f has frequency components at 0 and 1/2p Hz
f has frequency components at 0 and 1/p Hz
f has frequency components at 1/2p and 1/p Hz
f has frequency components at 0, l/2p and 1/p Hz

⇒ As compared to bipolar junction transistor, a FET
is less noisy
has better thermal stability
has higher input resistance
all of the above

⇒ A quiescent state of a transistor implies
zero bias
no output
no distortion
no input signal

⇒ Output of a phase splitter is
a pair of sine waves of unequal amplitude
a pair of sine waves of equal amplitudes
a pair of sine waves of equal amplitudes and opposite phase
a pair of sine waves of unequal amplitudes and opposite phase

⇒ Magnetic hysteresis phenomenon is explained by
motion of domain walls
motion of domain walls and domain rotation
domain rotation
none of the above

⇒ For the system of the given figure |G(jω)| = 0 dB at &omeg
0
1 rad/sec.
∞
2.38 rad/sec.

⇒ When a ferromagnetic substance is magnetised, small changes in dimensions occur. Such a phenomenon is known as
magnetic hystresis
magnetic expansion
magneto striction
magneto calorisation

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased
dc output voltage and rms output voltage decrease in the same proportion
dc output voltage and rms output voltage decrease
dc output voltage and rms output voltage increase
dc output voltage and rms output voltage increase in the same proportion