Question is ⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by, Options are ⇒ (A) 10 ω, (B) 15 ω, (C) 25 ω, (D) 40 ω, (E) , Leave your comments or Download question paper.

Question is ⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by, Options are ⇒ (A) 10 ω, (B) 15 ω, (C) 25 ω, (D) 40 ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by
A.	10 ω [Wrong Answer]
B.	15 ω [Wrong Answer]
C.	25 ω [Correct Answer]
D.	40 ω [Wrong Answer]
View Answer 15 -37 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Battery charging equipment should be installed
in well ventilated, clean and dry place.
as near as practical to the battery under charge.
both (a) and (b).
wherever convenient.

⇒ During electroplating the weight of a substance deposited depends upon
shape of the article
quantity of electricity
room temperature
all of the above

⇒ The current capacity of the charged secondary cell does not depend on
Rate of discharge
Temperature
Amount of active material
Rate of charging

⇒ Common impurity in a battery electrolyte is
dust particles.
iron.
lead crystals.
sodium chloride.

⇒ Which of the following acts as depolariser in Lechlanche cell ?
MnO₂
NH₄Cl
Mn₂O₃
ZnCI₂

⇒ In a lead acid battery, the level of the electrolyte should be
equal to that of the plates.
below the level of plates.
above the level of plates.
none of the above.

⇒ Which of the following tests is performed for ascertaining whether the battery plates are defective or not?
Specific gravity test.
High discharge test.
Cadmium test.
None of the above.

⇒ What causes lower efficiency of alkali cell as compared to the acid cell ?
Lower emf
Small amount of electrolyte
Longer life
Higher internal resistance

⇒ The emf of a lead battery
increases with the increase in specific gravity of the electrolyte.
slightly increases with the increase in temperature.
decreases with the increase in temperature.
both (a) and (b).

⇒ If the specific gravity of the electrolyte in a lead acid cell increases beyond 1.23 there will be
loss of life.
loss of capacity.
increase in internal resistance.
corrosion of the grids of the plate.

⇒ The condition of a fully charged lead acid battery cannot be ascertained by
gassing.
voltage.
colour of the electrodes.
specific gravity of the electrolyte.

⇒ During charging and discharging of an Edison cell
electrolyte does not take part in chemical reaction.
emf remains the same.
corrosive fumes are produced.
nickel hydroxide remains unsplit.

⇒ Addition of which of the following substances in electrolyte promotes smooth deposition?
Albumen.
Glucose.
Phenol.
Any of these.

⇒ For keeping the lead acid battery terminals free from corrosion it is advisable to
keep electrolyte level low
apply petroleum jelly.
charge the battery at frequent intervals.

⇒ For achieving uniform thickness of deposit on irregular surface
anode and cathode are kept farther apart
anode and cathode are kept closer.
high current densities are used.
electrolyte is agitated constantly

⇒ In a lead acid battery, separators are provided to
reduce internal resistance.
facilitate flow of the current.
avoid internal short circuits.
increase the energy efficiency.

⇒ Which of the following is not the name of a secondary cell ?
Acid cell
Alkali cell
Fuel cell
Storage cell

⇒ During discharging of lead acid cells, the terminal voltage decreases with the decrease in
temperature.
discharge rate.
state of charge.
none of these.

⇒ First electrochemical cell was designed by
Galvani
Faraday
Lechlanche
None of these

⇒ Whithin the electric cell, the charge is transported by
Free electrons
Only positive ions
Only negative ions
Both positive and negative ions

⇒ Through an electrolyte an electric current is due to drift of
Free electrons
Positive and negative ions
Free electrons and holes
Protons

⇒ Sulphated cells are indicated by the
low specific gravity.
low voltage on discharge.
low capacity.
all of the above.

⇒ Vent plug is provided in each lead acid cell to
pour water or electrolyte when needed.
check the electrolyte level.
allow escape out of gases during charging.
all of the above.

⇒ In a lead acid battery, excessive formation of lead sulphate occurs due to
idleness of battery for a long time.
low level of electrolyte.
persistent undercharging.
all of the above.

⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
atomic weights.
valency.
chemical equivalents.
atomic numbers

⇒ The arrangement of 12 cells, each of internal resistance 1.5 ω, to give maximum current in external load resistance of 2 ω will be
all 12 cells in series.
all 12 cells in parallel.
4 cells in series with 3 rows in parallel.
3 cells in series with 4 rows in parallel.

⇒ Internal resistance of primary cell varies
inversely with the distance between electrodes.
inversely with the surface area of electrodes.
directly with the distance between electrodes
with the nature of electrodes.

⇒ The current capacity of a cell is measured in
A
Ah
W
Wh

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ The capacity of a lead acid battery does not depend upon
charge rate.
discharge rate.
temperature.
density of electrolyte & quantity of active material.