Question is ⇒ A balun provides an impedance transformation of, Options are ⇒ (A) 0.667361111111111, (B) 0.334027777777778, (C) 0.167361111111111, (D) 0.0840277777777778, (E) , Leave your comments or Download question paper.

Question is ⇒ A balun provides an impedance transformation of, Options are ⇒ (A) 0.667361111111111, (B) 0.334027777777778, (C) 0.167361111111111, (D) 0.0840277777777778, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A balun provides an impedance transformation of
A.	0.667361111111111 [Wrong Answer]
B.	0.334027777777778 [Wrong Answer]
C.	0.167361111111111 [Correct Answer]
D.	0.0840277777777778 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ Figure is a 24 V_r stabilized power supply. The zener is 24 V, 600 mW. The minimum zener current is 10 mA. Proper values R and maximum load current
320 Ω, 10 mA
400 Ω, 15 mA
400 Ω, 10 mA
320 Ω, 15 mA

⇒ A discrete time linear shift-invariant system has an impulse response h[n] with h[0] = 1, h[1] = - 1, h[2] - 2, and zero otherwise. The system is given an input sequence x[n] with x[0] - x[2] - 1, and zero otherwise. The number of nonzero samples in the output sequence y[n], and the value of y[2] are, respectively
5, 2
6, 2
6, 1
5, 3

⇒ In force voltage analogy the quantity analogous to spring constant K is
R
C
L
1/C

⇒ Zero bias works only with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ In air friction damping
the air pressure opposes the motion of piston when it is moving inwards
the air pressure opposes the motion of piston when it is moving outwards
the air pressure opposes the motion of piston both when it is moving inwards as well as outwards
the air pressure may oppose or aid the motion of piston depending on the design

⇒ The symbol in figure is
SUS
SBS
SCS
None of the above

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above

⇒ Two currents have the same peak value. Wave 1 is sinusoidal and wave 2 is rectangular. The ratio of their heating effects are
0.0423611111111111
1 : 2
0.0430555555555556
0.000711805555555555

⇒ Noise can be measured by
D.C. voltmeter
A.C. voltmeter
either of the above
none of the above

⇒ The symbol in figure is
UJT
PUT
SCS
SBS

⇒ LCD uses
nematic crystals
sematic crystals
cholesteric crystals
twisted nematic crystal

⇒ Three resistance of 15 Ω each are connected in delta. The resistance of equivalent star will have a value of
15 Ω
5 Ω
5/3 Ω
45 Ω

⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0⁺ the current through
0.166666666666667
2.5 A
3.1 A
0

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A delta connection contains three impedances of 60 Ω each. The impedances of equivalent star connection will be
15 Ω
20 Ω
30 Ω
40 Ω

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ In the circuit shown in the figure, the approximate voltage at the transist
base and emitter respectively are -8 V and -7.3 V
base and collector respectively are -8 V and -5 V
Collector and emitter respectively are -5 V and -7.3
base, emitter and collector respectively are -8 V, 7.3 V and -5 V

⇒

Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops

Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is
1 mA
27.386 mA
1.268 mA
5.393 mA

⇒ If luminance signal Y = 0.3 R + 0.59 G + 0.11 B, the hue of R - Y colour is
0.7 R - 0.59 G - 0.11 B
- 0.7 R + 0.59 G + 0.11 B
1.3 R - 0.59 G - 0.11 B
none of the above

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is
1
0.7
0.2
1.4

⇒ In radio receivers, the value of IF is
100 kHz
225 kHz
455 kHz
850 kHz

⇒ The sum of two or more arbitrary sinusoidal is
always periodic
periodic under certain conditions
never periodic
periodic only if all the sinusoidals are identical in frequency and phase

⇒ Two numbers in excess-3 code are added and the result is less than 8. To get equivalent binary
0011 is subtracted
0011 is added
0110 is subtracted
0110 is added

⇒ In a pulsed RADAR typical value of pulse duration and pulse frequency respectively are
1 μs and 50 Hz
1 μs and 500 Hz
4 μs and 50 Hz
4 μs and 500 Hz

⇒ The semiconductor diode which can be used in switching circuit in microwave range is
PIN diode
Varactor diode
Tunnel diode
Gunn diode

⇒ For the time domain response shown in figure the
lies in left half plane
lies on imaginary axis
lies along the positive real axis
may be complex or imaginary