Question is ⇒ A 7477 decoder drives, Options are ⇒ (A) seven-segment display, (B) nickel tape, (C) relays, (D) diode matrix, (E) , Leave your comments or Download question paper.

Question is ⇒ A 7477 decoder drives, Options are ⇒ (A) seven-segment display, (B) nickel tape, (C) relays, (D) diode matrix, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 7477 decoder drives
A.	seven-segment display [Correct Answer]
B.	nickel tape [Wrong Answer]
C.	relays [Wrong Answer]
D.	diode matrix [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A band limited signal is sampled at the Nyquist rate. The signal can be recovered by passing the samples through
an RC filter
an envelope detector
a PPL
an ideal low pass filter with the appropriate bandwidth

⇒ An intrinsic silicon sample has 2 million free electrons. The number of holes in the sample is
2 million
almost zero
more than 2 million
less than 2 million

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ A MOD - 2 counter, the FF has a t_pd = 60 nsec. The NOR gate has a t_pd of 30 nsec. The clock frequency is
37 MHz
40 MHz
111 MHz
none

⇒ A wave trap is a
series tuned circuit
a parallel tuned circuit
either a series tuned circuit or parallel tuned circuit
none of the above

⇒ If we need a low noise device, we should use
BJT
FET
thyristor
UJT

⇒ Wire-wound resistors are unsuitable for use at high frequencies because they
are likely to melt under excessive eddy current heat
exhibit unwanted inductive and capacitive effects
create more electrical noise
consume more power

⇒ Consider the following statements

Acceptor level lies close the valence band.
Donor level lies close to the valence band.
n type semiconductor behaves as an insulator at 0 K.
p type semiconductor behaves as an insulator at 0 K.

Of these statements:
2 and 3 are correct
1 and 3 are correct
1 and 4 are correct
3 and 4 are correct

⇒

Assertion (A): In microprocessor 8085 instruction LXIB, 90 FF H means register B and C are loaded with upper and lower bytes to get B = 90 H and C = FFH.

Reason (R): In 8085 the stack pointer indicates which memory location is to accessed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statements is/are true for the diamond structure?

Coordination number is four.
Packing fraction is 0.34
Copper crystallizes into diamond structure
Lattice is FCC.

1 only
1, 2 and 4
2 and 3 only
2, 3 and 4

⇒ When deflecting torque and braking torque in an energy meter are zero,
the disc rotates at steady speed
the disc is stationary
the disc accelerates
the disc retards

⇒ Two voltages 50 V each have a phase difference of 45°. The rms value of resultant sum of the two voltages is
70.7 V
80.4 V
92.4 V
100 V

⇒ The accuracy of an instrument is determined by
closeness of indicated value to the actual value
repeatability of measured value
speed with which the reading approaches final value
least value which can be measured

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ A TV receiver is 40 cm wide and 30 cm high. The EHT supply required is about
2kV
20 kV
53 kV
10 W

⇒ A is even or B is true. Negation of above statement is
A is odd or B is false
A is odd and B is false
A is even or B is false
A is even and B is false

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point

⇒ A two branch parallel tuned circuits has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. The bandwidth is 200 radians/sec. A load of resistance R_L is connected in parallel. The new bandwidth will be
200 rad/sec
more than 200 rad/sec
less than 200 rad/sec
200 rad/sec or less

⇒ Current in a 2H inductance in 10e^-t A. Admittance of the inductor is
-0.5 mho
0.5 mho
5 mho
10 mho

⇒ Calculate the wave number in waveguide having dimensions 4 x 2 cm at 3 GHz
6.28
62.8
8
0

⇒ In metals, the flow of current is due to
electrons
ions
holes
electrons and ions

⇒ A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
10
2
1
infinity

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ For the given circuit, the current
0.0833333333333333
0.208333333333333
0.291666666666667
0.333333333333333

⇒ If a = 0.995, I_E = 10 mA, I_CO = 0.5 mA, then I_CEO will be
100 μA
25 μA
10.1 μA
10.5 μA

⇒ If we manage to __________ our natural resources, we would leave a better planet for our children.
uphold
restrain
Cherish
conserve

⇒ For measuring current at a high frequency we should use
moving iron instrument
electrostatic instrument
thermocouple instrument
moving coil instrument

⇒ The echo heard by a telephone user on a satellite channel can be removed by using
a vocoder
a multiplexer
echo suppressor
digital techniques

⇒ Examine the following statements

Air and gases are compressible.
Air, gases and some liquids are compressible.
Oil can function as hydraulic fluid as well as lubricator.

Which of the above statements are correct?
3 only
2 and 3 only
1 and 3 only
2 only