Question is ⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion., Options are ⇒ (A) 5.85 V, (B) 6 V, (C) 5 V, (D) 10 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion., Options are ⇒ (A) 5.85 V, (B) 6 V, (C) 5 V, (D) 10 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
A.	5.85 V [Correct Answer]
B.	6 V [Wrong Answer]
C.	5 V [Wrong Answer]
D.	10 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ac wave with superimposed dc is symmetrical about x - axis.
TRUE
FALSE

⇒ In a 4 bit ripple counter using flip flops with t_pd = 40 ns, the maximum frequency can be
1.25 MHz
3.25 MHz
6.25 MHz
12.5 MHz

⇒ Which of the following can be used as a buffer amplifier?
CE
CC
CB
Both (a) and (c)

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ In FM and AM the ratio of signal to noise ratio at the detector output least depends upon
bandwidth
transmission
carrier frequency
modulating frequency

⇒ The antenna current of an AM transmitter is 8 A, when only the carrier is sent, but it increases to 8.93 A when the carrier is modulated by a single sine wave. Determine the antenna current when the percent of modulation changes to 0.8
9.19 A
9.91 A
10.56 A
8.61 A

⇒ For the wave shown in figure, the average and rms values
50 A and 57.73 A
57.73 A and 50 A
25 A and 57.73 A
57.73 A and 70.7 A

⇒ When UJT is used for thyristor gate signal, the output of UJT is
sine wave
square wave
saw tooth wave
either (a) or (c)

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒

Assertion (A): Millman's theorem helps in replacing a number of current sources in parallel by a single current source.

Reason (R): Maximum power transfer theorem is applicable only for dc, circuits.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than
5 W
10 W
20 W
40 W

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ Occasionally a discrete amplifier user RF chokes instead of collector resistors. Such amplifiers are inherently
low pass amplifiers
high pass amplifiers
band pass amplifiers
none of the above

⇒ For good quality signal transmission all frequency components should have the same transmission delay, t_d and same phase shift-Φ_s. What can be said about the statement?
Correct
True from t_d but not for Φs
Not true for t_d but true for Φ_s
Both t_d and Φ_s are not involved in quality

⇒ The problem associated with tuned-radio frequency receiver is
instability
insufficient adjacent frequency rejection
bandwidth variation
all of the above

⇒ Unit doublet is the Laplace inverse of __________ .
1/s
s²
s
none of these

⇒ In a power amplifier the collector current flows for 270° of the input cycle. The operations is
class A
class B
class AB
class C

⇒ Symbol shown in figure represen
P-channel enhancement MOSFET
N-channel DEMOSFET
UJT with P-type base
UJT with N-type base

⇒ In the circuit of figure, v_{03 v₁ + 4 v₂
-3 v₁ - 4 v₂
4 v₁ + 3 v₂
-4 v₁ - 3 v₂}

⇒ Thermal run away of a transistor occurs when
heat dissipation from transistor is excessive
transistor joints melt due to high temperature
there is excessive leakage current due to temperature rise
none of the above

⇒ Which one of the following materials is used for making permanent magnets?
Steel
Carbon
Carbon-Steel
Graphite

⇒ How many interrupts are there in 8085 microprocessor?
4
5
6
8

⇒ DC voltage of the order of a few mV can be accurately of measured by
PMMC voltmeters
moving iron voltmeter
null balancing potentiometer
electrostatic voltmeter

⇒ Which of the following circuit can operate class AB for audio power output?
Push pull
Cascade
Pull down
Darlington pair

⇒ 7483 is a TTL binary adder. It can add
two 4-bit binary numbers
four 6-bit binary numbers
four 8-bit binary numbers
any number of 4-bit numbers

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m²
716 m²
7.16 m²
71.6 m²

⇒ A generator is feeding power to a transmission line of characteristic impedance Z₀. The line is terminated in impedance Z_L. Standing waves will be set up if
Z_L = Z₀
Z_L < Z₀
Z_L > Z₀
both (b) and (c)

⇒ The power requirement of a RADAR used in military operations is
a few watts
about 500 W
about 2000 W
a few megawatts

⇒ A fully controlled bridge converter feeds a highly inductive load such that the load current can be assumed to be constant. The wave shape of input current is
dc
sinusoidal
rectangular
none of the above