Question is ⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?, Options are ⇒ (A) 0.375 V, (B) 15 V, (C) 4.5 V, (D) 10 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?, Options are ⇒ (A) 0.375 V, (B) 15 V, (C) 4.5 V, (D) 10 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?
A.	0.375 V [Correct Answer]
B.	15 V [Wrong Answer]
C.	4.5 V [Wrong Answer]
D.	10 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Q of a coil

increases with Q increasing frequency
varies linearly with frequency
increase with increasing frequency because R increases at high frequency
decrease after the peak frequency because R increases at H.F. the correct statements are

A, B
C, D
A, C
B, D

⇒ The sensitivity of a voltmeter using 0-5 mA meter movement is
50 Ω/V
100 Ω/V
200 Ω/V
500 Ω/V

⇒ Which is a valid Java variable?
1 a b
56 a
a 56
5 a 6

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒ Directivity and beamwidth is related as
D ∝ B
D ∝ 1/B
D ∝ B
D ∝ B²

⇒ In the circuit shown in the given figure, power dissipated in the 5 Ω resisto
zero
80 W
125 W
405 W

⇒ In figure, the switch has been in closed position for a long time. At t = 0, the switch is opened. At t = 0⁺, the current R_{10.333333333333333
0.166666666666667
0.25
0.0833333333333333}

⇒ In figure, R = 20KΩ and C = 75 pF. The converter clock frequency wil
606 Hz
1212 Hz
555 KHz
606 KHz

⇒ If E (i.e., available energy state) = E_F(i.e., Fermi level), then probability that state E will be occupied is 0.5 for any temperature T.
TRUE
FALSE

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ Which one of the following is a cut set of the graph in the given fig
1, 2, 3, and 4
2, 3, 4, and 6
1, 4, 5, and 6
1, 3, 4, and 5

⇒ Which of the following is not a necessary advantage of negative feedback system?
Feedback improves speed of response
Feedback improves stability
Feedback reduces effect of variations in system parameters
Feedback reduces the effect of external disturbances

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ In a purely resistive circuit the instantaneous power varies from zero to maximum twice in each cycle.
TRUE
FALSE

⇒ In figure which diode will conduct and what will be the value of V_{0D₃, 1 V
D₁, 2 V
D₂, 5 V
D₁, 5 V}

⇒ A moving coil meter has 10 Ω resistance and requires 40 mA for full scale deflection. The shunt resistance required to convert it into 0-2 A ammeter is
0.1021 Ω
0.2041 Ω
0.256 Ω
0.4210 Ω

⇒ In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .
low, low
high, high
low, high
high, low

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ Which of the following devices is a 'hot-electron' diode?
Thermionic tube diode
Schottky-Barrier diode
Thomson-Deletion diode
Thermal electron diode

⇒ Read the following rules for scanning Boolean expressions in Pascal

The expressions are scanned from left to right.
The operations are scanned in the order NOT, AND, OR.
All operators (i.e., NOT, AND and OR) are scanned together.
In one scanning all the operators of only one type are scanned.

Which of the above are correct?
All
1, 2 and 3 only
1, 2 and 4 only
2, 3 and 4 only

⇒ A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be
R/3
3 R
R/9
9 R

⇒ In figure, the switch is closed at t = 0 when current through inductor is 6 A, the rate of change of current through resistor is 6 A/s. The value of
1 H
2 H
3 H
4 H

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ A function table is required in very large numbers the memory most switched for this purpose would be
ROM
PROM
EPROM
EAROM

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be __________ amperes.
141.4
200
200/p
40/p

⇒ The troposphere extends from earth surface to a height of
15 km
90 km
150 km
200 km

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease