Question is ⇒ A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is, Options are ⇒ (A) 1.5 V, (B) 2.0 V, (C) 3.0 V, (D) 4.5 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is, Options are ⇒ (A) 1.5 V, (B) 2.0 V, (C) 3.0 V, (D) 4.5 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 4 bit DAC gives an output of 4.5 V for input of 1001. If input is 0110, the output is
A.	1.5 V [Wrong Answer]
B.	2.0 V [Wrong Answer]
C.	3.0 V [Correct Answer]
D.	4.5 V [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The gall tinsley potentiometer is a coordinate potentiometer and has two exactly similar potentiometers.

Reason (R): An ac potentiometer may measure the unknown voltage in polar form or rectangular coordinate form.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is R_L and filter capacitance is C. For good output wave shape, the time constant R_LC should be at least equal to
10 ms
20 ms
50 ms
100 ms

⇒ If ωε is the displacement current factor and s is conduction current density factor then which of the following statements is incorrect?
For a lossless dielectric σ = 0
For an imperfect dielectric σ = 0
For a dielectric ωε >> σ
For a semiconductor ωε = σ

⇒ Δ²V = - r/E is known as __________ equation
Poisson
Fourier
Laplace
Maxwell

⇒

Assertion (A): Hay's bridge in particularly suitable for measuring inductance having a comparatively low resistance.

Reason (R): In Hay's bridge the value of frequency supply must be known.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A 6 MHz channel is used by a digital signalling system initializing four-level signals. The maximum possible transmission rate is
6M bands/s
12M bands/s
6 M bits/s
12M bits/s

⇒ MOS circuits as compared to bipolar circuits take
more chip area
less chip area
same chip area
none of these

⇒ A copper coil has a resistance of 40 ohm at 20°C. At 100°C the resistance is likely to be
44 Ω
54 Ω
84 Ω
104 Ω

⇒ In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?
INTR
RST 5.5
RST 7.5
TRAP

⇒ What is meant by "continuous collector current" in BJT?
Maximum collector current
Current at Quiescent condition
Leakage current
Junction Capacitance charging and discharging current

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ The stud in a stud mounted SCR acts as
anode
cathode
gate
anode or cathode

⇒ As compared to LED, LASER has

higher emission efficiency
no tuning arrangement
narrow spectral width
provision for confinement

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1 and 3 are correct
1, 3, 4 are correct

⇒ A 200 Hz sound wave is to be transmitted by a 1000 kHz radio wave using frequency modulation. The instantaneous frequency variation will be
100 times a second
200 times a second
400 times a second
1000 times a second

⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒ The orientation polarization of a polyatomic gas is inversely proportional to absolute temperature.
TRUE
FALSE

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ Determine the potential difference between the points A and B in the steady s
40 V
60 V
25 V
75 V

⇒ A half wave diode rectifier has a capacitance input filter. If input voltage is V_m sin ωt, PIV is
V_m
2 V_m
3 V_m
4 V_m

⇒ Assuming that flip-flops are in reset condition initially, the count sequence observed at Q_A in the circuit show
0010111...
0001011...
0101111...
0110100...

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ A circuit said to be lumped when physical dimensions of all the component are __________ .
greater compared with wavelength of electromagnetic signal
small compared with wavelength electromagnetic signal
negligible compared with wavelength of electromagnetic signal
equal compared with wavelength of electromagnetic signal

⇒

Assertion (A): A PROM can be used as a synchronous counter

Reason (R): Each memory location in a PROM can be read synchronously.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒ Recommended fanout for ECL is
5
10
15
25

⇒ Which of the following instructions have only one operand?
Multiply
Add
Shift
Subtract