Question is ⇒ A 4 bit counter with four flip-flops will count upto decimal, Options are ⇒ (A) 8, (B) 15, (C) 31, (D) 63, (E) , Leave your comments or Download question paper.

Question is ⇒ A 4 bit counter with four flip-flops will count upto decimal, Options are ⇒ (A) 8, (B) 15, (C) 31, (D) 63, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 4 bit counter with four flip-flops will count upto decimal
A.	8 [Wrong Answer]
B.	15 [Correct Answer]
C.	31 [Wrong Answer]
D.	63 [Wrong Answer]
View Answer 3 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In switching devices, gold doping is used to
improve bonding
reduce storage time
increase the mobility of the carrier
protect the terminals against cooperation

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2

⇒

Assertion (A): Hay's bridge in particularly suitable for measuring inductance having a comparatively low resistance.

Reason (R): In Hay's bridge the value of frequency supply must be known.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which one of the following cannot be used to remove the unwanted sideband in SSB?
Balanced modulator
Phase shift method
Filter system
Third method

⇒ The current rating of a cable depends on
length of cable
diameter of cable
both length and diameter of cable
none of the above

⇒

Assertion (A): The unit of telephone traffic measurement is erlang.

Reason (R): International circuits for communication are fitted with echo suppressors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When an electric field E is applied to solid and liquid insulating materials, the internal field E_i acting at the location of atom is such that
E_i = E
E_i > E
E_i < E
E_i may be equal to or less than E

⇒ The disadvantage of transformer coupling in amplifier is
cost of transformer at audio frequencies
size of transformer at audio frequencies
size of transformer at radio frequencies
cost and size of transformer at audio frequencies

⇒

Match the following:

	List I		List II
A.	Darlington amplifier	1.	A circuit using pnp and npn transistors
B.	CB amplifier	2.	A CS amplifier driving a CG amplifier
C.	Cascade amplifier	3.	A circuit with over-all voltage gain close to 1 and very large input impedance
D.	Complementary symmetry amplifier	4.	A circuit with low input impedance

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ Find L_eq if each L is
4/3 H
1/3 H
2/3 H
3/2 D

⇒ A series RC circuit has R = 5 Ω and C = 10 μF. The current in the circuit is 5 sin 20000t. The applied voltage is
252 sin (20000t + 45°)
252 sin (20000t - 45°)
252 sin 20000t
252 sin (20000t - 90°)

⇒ The circuit shown depic
voltage series negative feedback
voltage shunt negative feedback
current series negative feedback
current shunt negative feedback

⇒ In a 741 OP-amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to
applied load
internal compensation
impedance of the source
power dissipation in the chip

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ The gate electrode in the FET corresponds to the
collector in a bipolar transistor
base in a bipolar transistor
emitter in a bipolar transistor
none of the above

⇒ In a power diode the reverse recovery time is the time from the instant the forward current is zero to the instant when reverse recovery current has decayed to
50% of peak reverse current
25% of peak reverse current
10% of peak reverse current
zero value

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10⁶ rad/sec. The possible combination of R, L,
2.5Ω, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 μF
5 kΩ, 0.1 mH, 0.4 μF

⇒ If interrupt service request have been received from all of the following interrupts, then which one will be serviced last?
RST 5.5
RST 6.5
RST 7.5
None of these

⇒ The charge of an electron is
1.6 x 10^-17 coulomb
1.6 x 10^-19 coulomb
1.6 x 10^-21 coulomb
1.6 x 10^-23 coulomb

⇒ Consider the following:

Si
Ge
GaAs
InP

Which of the above semiconductors should be used for making highly efficient photodiodes?
1 and 4 only
3 and 4 only
1, 3 and 4
2, 3 and 4

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒ For an antenna of height h_t metres, the radio horizon is equal to
4h_t metres
4h_t km
2.5h_t km
2.5h_t metres

⇒ The counter shown in the given figure is built using 4 -ve edge triggered toggle FFs. The FF can be set asynchronously when R = 0. The combinational logic required to realize a modulo-13 counte
F = Q₄ Q₃ Q₂ Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄Q₃Q₂Q₁

⇒ If the plate supply voltage for a plate modulated class C amplifier is E, the maximum plate cathode voltage could be almost as high as
E
2 E
3 E
4 E

⇒ A Clapp's oscillator is
a modified Hartley oscillator
a modified Colpitt's oscillator
a modified RC oscillator
none of the above

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ Which rectifier has the best ratio of rectification?
Half wave rectifier
Full wave rectifier
Bridge rectifier
Three phase full wave rectifier