Question is ⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if, Options are ⇒ (A) load torque is constant, (B) load torque increases with increase in speed, (C) load torque decreases with increase in speed, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if, Options are ⇒ (A) load torque is constant, (B) load torque increases with increase in speed, (C) load torque decreases with increase in speed, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
A.	load torque is constant [Wrong Answer]
B.	load torque increases with increase in speed [Correct Answer]
C.	load torque decreases with increase in speed [Wrong Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 4 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A satellite that simply reflect back the signals from one region of the earth to the other region is known as
orbiting satellite
geostationary satellite
active satellite
passive satellite

⇒ In figure, power in 6 Ω resistor is zero then
202∠45°
20 ∠30°
20 ∠45°
202∠30°

⇒ How many free electrons does a p type semiconductor has?
only those produced by thermal energy
only those produced by doping
those produced by doping as well as thermal energy
any of the above

⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0

⇒ DS directive in 8085
forces the assembler to reserve one byte of memory
forces the assembler to reserve a specified number of bytes in the memory
forces the assembler to reserve a specified number of consecutive bytes in the memory
none of the above

⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
60 and 15
15 and 60
6 and 1.5
1.5 and 6

⇒ The input impedance of CRO is about
zero
10 Ω
100 Ω
one mega ohm

⇒ In figure, thyristor Th is in off state. When thyristor is turned on, the peak thyristor current can
0.208333333333333
0.416666666666667
15 A
20 A

⇒ In a linear bilateral passive element two port which of the following holds for z parameters?
z₁₁ = z₂₂
z₁₂ z₂₂ = z₁₁ z₂₂
z₁₁ z₁₂ = z₂₂ z₂₁
z₁₂ = z₂₁

⇒ In the circuit, the value of the voltage source
-22 V
-12 V
+12 V
-10 V

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high

⇒ A 'n' bit sequence generator employing SR flip-flop has maximum length of the sequence as :
2ⁿ
n
2ⁿ - 1
2ⁿ^-1

⇒ When transient and steady state response require improvement; a __________ is used.
Lead compensator
Lag - Lead compensator
Lag compensator
Integrator

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ The difference between phase and frequency modulation
is purely of academic interest
lies in the different definitions of the modulation index
lies in the poor audio response of phase modulation
is too great to make the two systems compatible

⇒ With respect to the differential amplifier configuration shown below, the differential gain A_d will
273.63
213.63
113.63
233.63

⇒ CW Doppler radar is capable of giving accurate measurements of relative velocities.
TRUE
FALSE

⇒ A loop antenna is a commonly used for
radar
direction finding
satellite communication
all of the above

⇒ A divide by 78 counters can be realized by using
six mod-13 counters
thirteen mod-6 counters
one mod 13 counter followed by one mod-6 counter
thirteen mod-13 counters

⇒

Assertion (A): An impulse has very high magnitude but very small duration.

Reason (R): A pulse function is always rectangular.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If 137 + 276 = 435 how much is 731 + 672?
534
1403
1623
1513

⇒ Which SNR denotes excellent picture quality in TV?
50 dB
30 dB
15 dB
5 dB

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒

Assertion (A): In Fortran 77 the statement IMPLICIT INTEGER (A - E) identifies all variable name which begin with A, B, C, D, or E as being of integer type.

Reason (R): IMPICIT statement in Fortran 77 is an improvement over earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For an ideal 3000 Hz channel, Nyquist rate is
3000 bps
6000 bps
9000 bps
12000 bps

⇒ The forbidden energy gap between the valence band and conduction band will be least in case of
metals
semiconductors
insulators
all of the above