Question is ⇒ A 3 input NAND gate is to be used as inverter. Which of the following will give better results?, Options are ⇒ (A) The two unused inputs are left open, (B) The two unused inputs are connected to 0, (C) The two unused inputs are connected to 1, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A 3 input NAND gate is to be used as inverter. Which of the following will give better results?, Options are ⇒ (A) The two unused inputs are left open, (B) The two unused inputs are connected to 0, (C) The two unused inputs are connected to 1, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 3 input NAND gate is to be used as inverter. Which of the following will give better results?
A.	The two unused inputs are left open [Wrong Answer]
B.	The two unused inputs are connected to 0 [Wrong Answer]
C.	The two unused inputs are connected to 1 [Correct Answer]
D.	None of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ Which one of the following parameters does not exist for the two port network shown in the given fig
ABCD
y
h
z

⇒ The dual of a loop is
twig
node pan
mesh
tree

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ Computer communication networks have
star configuration
tree configuration
loop/mesh configuration
All of the above

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ Klystron amplifier is not used to amplifier very weak microwave signals due to
low gain for weak signals
low noise for weak signals
high noise
both (a) and (b)

⇒ A uniform plane EM wave incident normally on a plane surface of a dielectric material is reflected with a VSWR of 3. What percentage of incident power that is reflected?
0.1
0.25
0.5
0.75

⇒ A system has high gain and phase margin. The system is
very stable
sluggish
very stable and sluggish
oscillatory

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ The inputs to a 3 bit binary adder are 111₂ and 110₂. The output will be
101
1101
1111
1110

⇒ Mouse is a very suitable input device for computers.
TRUE
FALSE

⇒ A line has Z₀ = 300 ∠ 0° Ω. If Z_L = 150 ∠ 0° Ω, reflection coefficient is
0.5
0.3333
-0.3333
-0.5

⇒ Which of the following statements defines a full adder?
It adds two binary digits and produces their SUM and CARRY
It adds three inputs (two binary digits and a carry) and produces their SUM and CARRY
It has two inputs and two outputs
None of the above

⇒ Find cut off wavelength for mode TE₁₁ in a circular waveguide having radius 2 cm. Assume K'_a = 1.841
4 cm
6.82 cm
8 cm
68.2 cm

⇒ The self bias provides
stable Q point
large voltage gain
high input impedance
high base current

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured
at lowest gain crossover frequency
at highest gain crossover frequency
at the gain crossover frequencies
none of the above

⇒ In an ac circuit, the maximum and minimum values of power factor can be
2 and 0
1 and 0
0 and -1
1 and -1

⇒ At room temperature, a possible value for the mobility of electrons in the inversion layer of a silicon n-channel MOSFET is
450 cm²/V-s
1350 cm²/V-s
1800 cm²/V-s
3600 cm²/V-s

⇒ The Boolean expression B⊕E is a simplified version of expression ABE + BCDE+ BC D E + A B D E + B C D E + A B D E then which of the following choice is correct?

don't care conditions doesn't exist
don't care conditions exist
d( 16, 18, 20, 23, 27, 29) is the set of don't care conditions
d( 16, 20, 22, 27, 29) is the set of don't care conditions

1 only
2 and 3 only
2 and 4 only
data insufficient

⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None

⇒ In forward active region, the operation of a BJT
both junctions are forward biased
both junctions are reverse biased
emitter base junction is forward biased and base collector junction is reverse biased
emitter base junction is reverse biased and base collector junction is reverse biased

⇒ A voltage tripler circuit and voltage quadrupler circuit use identical components. Then
voltage regulation in both circuits will be same
voltage regulation in both may or may not be same
voltage regulation in quadrupler circuit will be better than in tripler circuit
voltage regulation in quadrupler circuit will be poorer than in tripler circuit

⇒ In a hot wire instrument, the deflection is proportional to
peak value of ac current
average value of ac current
rms value of ac current
either (a) or (b)

⇒ Integrated fin line can be utilized as a medium for constructing millimeter wave circuits.
TRUE
FALSE

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?
Resistance triggering
Simultaneous triggering
Sequential triggering
Optical triggering

⇒ Which of the following is used for generating time varying wave forms?
MOSFET
PIN diode
Tunnel diode
UJT

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high