Question is ⇒ A 2 bit BCD D/A converter is a weighted resistor type with ER = 1V, R = 1 MΩ and Rf = 10KΩ then Resolution in percent and volt is __________ ., Options are ⇒ (A) 1%, 1 mv, (B) 10%, 10 mv, (C) 10%, 1 mv, (D) 1%, 10 mv, (E) , Leave your comments or Download question paper.

Question is ⇒ A 2 bit BCD D/A converter is a weighted resistor type with ER = 1V, R = 1 MΩ and Rf = 10KΩ then Resolution in percent and volt is __________ ., Options are ⇒ (A) 1%, 1 mv, (B) 10%, 10 mv, (C) 10%, 1 mv, (D) 1%, 10 mv, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
A.	1%, 1 mv [Wrong Answer]
B.	10%, 10 mv [Wrong Answer]
C.	10%, 1 mv [Wrong Answer]
D.	1%, 10 mv [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ In Weston frequency meter, the magnetic axes of the two fixed coils are
parallel
perpendicular
inclined at 60°
inclined at 15°

⇒ A pure tone at 1000 Hz has a dB level of 40 dB. If the required dB level is 100, the number of such tones is
2.5
60
10⁴
10⁶

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage

⇒ The damping ratio of a pair of complex poles when expressed in terms of angle θ measured from jω axis equal to
sin θ
cos θ
tan θ
cot θ

⇒ In an FM signal, the modulating frequency is 2 kHz and maximum deviation is 10 kHz. The bandwidth requirement is
2 kHz
10 kHz
5 kHz
32 kHz

⇒ The transconductance curve of a JFET is
a straight line
parabolic
hyperbolic
inverted V-type

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ADI A4H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1

⇒

Assertion (A): Magnetic susceptibility of copper is -0.5 x 10^-5.

Reason (R): Copper is diamagnetic material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Copper is a monoatomic solid.

Reason (R): In a metal the valence electrons belong to all atoms.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A black box has one of the elements our of R, L, C. when a 220 V a supply is connected the current supplied by source is I. when a 0.1 F capacitor is connected in parallel with the box, the current is 2I. The element is
resistance
inductance
0.1 F capacitance
not identifiable on the basis of given data

⇒ Gauge factor of a strain gauge is
unit change in resistance per unit change in length
change in resistance per unit change in length
unit change in length per unit change in resistance
none of the above

⇒ Fastest memory cell
bubble memory
core memory
semiconductor memory
superconductor memory

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ Which of the following configuration has low thermal stability?
CB
CC
CE
All have identical thermal stability

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ The code which provides for parity check is
Baudot
ASCII
EBCDIC
Excess-3

⇒ The unit of loudness is
phon
sone
decibel
mel

⇒ The instruction MOV r₁, r₂ in 8085
causes contents of registers r₂ to be moved to r, and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register immediate addressing
causes contents of registers r₂ to be moved to r₁ and uses register immediate addressing

⇒ For the logic circuit of the given figure the simplified Boolean equa
Y = (A + B) (C + D) (E + F)
Y = A = B + C + D + E + F
ABCDEF
ABC + DEF

⇒ Dynamic range of hi-fi system is at least
150 dB
120 dB
80 dB
40 dB

⇒ The dimensions of permittivity are
L^-3M^-1T²Q²
L^-1M^-1T²Q²
L²MT^-1Q^-1
L^-2M^-1T²Q²

⇒ A lag compensator is essentially a
low pass filter
high pass filter
band pass filter
either (a) or (b)

⇒ Which one of the following power amplifier has the maximum efficiency?
Class A
Class B
Class AB
Class C

⇒ A bipolar differential amplifier uses a transistor having β₀ = 200, I_CQ = 100 mA, |A_dm| = 500 and CMRR = 80 dB. The value of R_c and R_E will be respectively __________ .
1.25 kΩ, 1.25 MΩ
125 kΩ, 1.25 MΩ
1.25 MΩ, 1.25 kΩ
3.25 kΩ, 3.25 MΩ

⇒ In low power factor wattmeter, the pressure coil is connected
to the supply side of current coil
to the load side of current coil
in either (a) or (b)
across the mains

⇒ A microwave junction is matched at all ports if the S matrix
has all diagonal elements zero
has all diagonal elements equal but not zero
has all diagonal elements complex
is Hermitian

⇒ The total number of leads in reverse conducting thyristor is
2
3
1
4

⇒ Given digits 2, 2, 3, 3, 3, 4, 4, 4, 4 how many distinct 4 digit numbers greater than 3000 can be formed?
50
51
52
54