Question is ⇒ A 16 bit counter type ADC uses 1 MH<i>z</i> clock then its maximum conversion time is __________ ., Options are ⇒ (A) 16 μ<i>s</i>, (B) 15 <i>ms</i>, (C) 6.6 <i>ms</i>, (D) 66 <i>ms</i>, (E) , Leave your comments or Download question paper.

Question is ⇒ A 16 bit counter type ADC uses 1 MH<i>z</i> clock then its maximum conversion time is __________ ., Options are ⇒ (A) 16 μ<i>s</i>, (B) 15 <i>ms</i>, (C) 6.6 <i>ms</i>, (D) 66 <i>ms</i>, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 16 bit counter type ADC uses 1 MHz clock then its maximum conversion time is __________ .
A.	16 μs [Wrong Answer]
B.	15 ms [Wrong Answer]
C.	6.6 ms [Wrong Answer]
D.	66 ms [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ The first contribution to logic was made by
George Boole
Copernicus
Aristotle
Shannon

⇒ The open loop frequency response of a unity feed back system is as u
20 dB and 15°
20 dB and 25°
6 dB and 15°
6 dB and 25°

⇒ Transverse magnetic (TM) waves have
magnetic field component H in the direction of propagation
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒ For an accurate clock period in 8085 it is preferable to use
Crystal
Crystal or LC resonant circuit
Crystal or RC circuit
LC or RC circuit

⇒ The following circuit is implementation of:

sum of full adder

carry of half adder

difference of full subtractor

1 only
3 only
2 only
1 and 2 both

⇒ Which class of amplifiers operates with least distortion?
Class A
Class B
Class C
Class AB

⇒ Piezoelectric quartz crystal resonators find application where
signal amplification is required
rectification of the signal is required
signal frequency control is required
modulation of signal is required

⇒ Which of the following frequencies has the greatest period?
20 Hz
200 Hz
20 kHz
200 kHz

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ The two outputs of RS flip-flop are
always low
always high
either low or high
always complementary

⇒ In a Weston synchronoscope the deflecting torque is zero when
currents in fixed and moving coils are in phase
currents in fixed and moving coils are out of phase by 90°
currents in fixed and moving coils are out of phase by 60°
none of the above

⇒ Figure shows the self bias circuit for CE amplifier and its equivalent circuit. V_BB and R_B respectively
10 V and 4 k ohm
5 V and 4 k ohm
2 V and 4 k ohm
2 V and 10 k ohm

⇒ In a decimal digital computer, the number 127 is stored
1111111
0001 00100111
10001
11000111

⇒ For a BJT a = 0.98, then β =
0.02
0.5
4.9
48

⇒ For a given voltage four heating coils will give maximum heat when connected
in parallel
in series
with two parallel pairs in series
with one pair in parallel and the other two in series

⇒ Serial input data of 8085 can be loaded into bit-7 of the accumulator by
executing a RIM instruction
executing RSTI
using TRAP
none of the above

Assertion (A): In a series resonant circuit current is maximum at resonance.

Reason (R): The inductive and capacitive reactances are equal.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Standard AM radio broadcasts are confined to
MF
HF
VHF
UHF

⇒ If the function A, B are A = R + PQ + RS B = PQRS + PQRS + PQRSA = B
A = B
no direct relation between A and B
insufficient data

⇒ For maximum unclipped output from a CE amplifier, the Q point should be
at the centre of dc load line
at the centre of ac load line
at the centre of collector current
none of the above

⇒ For a reflection co-efficient of 0.5, the value of SWR is
-1
1
2
3

⇒ A sawtooth current wave is passed through a resistance
the waveshapes of voltages across resistance and power will also the sawtooth
the waveshape of voltage across resistance will be sawtooth
the waveshape of power will be sawtooth
neither the voltage waveshape nor power wave-shape will be sawtooth

⇒ The number of TV channels which can be accommodated in a spectrum of 300 MHz is about
5
10
50
200

⇒ For the control system in the given figure, the value of K for critical dampin
1
5.125
6.831
10

⇒ The graph of a network has 6 branches with 3 tree branches. The minimum number of equations required for solution of network is
2
3
4
5

⇒ As regards rectangular and circular waveguides
both have infinite set of TE and TM modes
rectangular waveguide has infinite TE and TM modes but not the circular waveguide
circular waveguide has infinite TE and TM modes but not the rectangular waveguide
none of the above