Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
A 12 bit ADC is employed to convert an analog voltage of zero to 10 volts. The resolution of the ADC is | |
A. | 2.44 mV [Correct Answer] |
B. | 24.4 mV [Wrong Answer] |
C. | 83.3 mV [Wrong Answer] |
D. | 1.2 V [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Full duplex operation
requires modems at both ends of circuit
requires two pairs of cables
can transfer data in both directions simultaneously
all of the above
⇒ Addition of 0.3 to 3.5% silicon to iron
increases the electrical resistivity of iron
decreases the electrical resistivity of iron
does not change electrical resistivity of iron
silicon can't be added with iron
⇒ A two terminal black box contains one of the elements R, L, C. The black box is connected to 220 V as supply. The current is I, when a capacitance of 0.1 F is connected in series between the source and box, the current is 2I. The elements is
resistance
inductance
capacitance of 0.5 F
not identifiable form the given data
⇒ ROC of sequence x[n] = (3)^{n} ∪[n] + (4)^{n} ∪[- n - 1]
|z| > 4
3 < |z| < 4
|z| < 4
|z| > 3
⇒ 9's complement of 12_{10} is
21_{10}
87_{10}
78_{10}
76_{10}
⇒ A microstrip line has dielectric having relative permittivity ∈_{r}. The effective dielectric constant is
more than ∈_{r}
equal to 1
less than ∈_{r}
either a or b
⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resulting electric field inside the speciment will be in
direction normal to both current and magnetic field
the direction of current
direction antiparallel to magnetic field
an arbitrary direction depend upon conductivity
⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above
⇒ In Z_{RC} (s) has a pole at s = ∞, the last element in first Foster realization is
R
C
R and C in series
R and C in parallel
⇒ The two conductors of a transmission line carry equal current I in opposite direction. The force on each conductor is
proportional to I
proportional to I^{2}
proportional to distance between the lines
proportional to I^{3}
⇒ A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is a. The period of conduction of SCR and free wheeling diode respectively are
a < ωt < p and p < ωt < (2p + a)
a < ωt < p and p < ωt < 2p
a < ωt < (p + a) and (p + a) < ωt < 2p
a < ωt < p and p < ωt < (2p - a)
⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0
⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform
⇒ How many zone bits are th
2
4
8
16
⇒ PAL stands for
Phase Attenuation by Line
Phase Alternation by Line
Parabolic Alternation by Line
Picture Alternation by Line
⇒ The circuit given below
counter
digital to analog converter
two-bit series-to-parallel converter
analog-to digital converter
⇒ A lag compensator is essentially a
low pass filter
high pass filter
band pass filter
either (a) or (b)
⇒ If the characteristic equation of a closed loop system is s^{2} + 2s + 2, then the system is :
over damped
critically damped
under damped
undamped
⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111
⇒ A quantization error is an essential aspect of ADC
TRUE
FALSE
⇒ Permeance is analogue to
reluctance
conductance
capacitance
resistance
⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output
⇒ The logic function implemented by the following circuit at the terminal OU
P NOR Q
P NAND Q
P OR Q
P AND Q
⇒ Which of the following has unique representation of 0?
sign magnitude
1's complement
2's complement
both (b) and (c)
⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value
⇒ The sensitivity of electromagnetic digital flow meter can be increased by increasing
circumferential width of rotor teeth
radial depth of rotor teeth
thickness of rotor teeth
number of teeth
⇒ As B is increased from zero to about 2T, μ_{r}, of a ferromagnetic material
increase
decrease
first increases then decreases
remains the same
⇒ The contents of the commands register are 23 H. Then port C
is an input port
is an output port
is both input as well as output port
none of the above
⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter
⇒ If output power of a radio receiver is doubled, its volume is increased by __________ dB.
2
3
1
-3
⇒ Full duplex operation
requires modems at both ends of circuit
requires two pairs of cables
can transfer data in both directions simultaneously
all of the above
⇒ Addition of 0.3 to 3.5% silicon to iron
increases the electrical resistivity of iron
decreases the electrical resistivity of iron
does not change electrical resistivity of iron
silicon can't be added with iron
⇒ A two terminal black box contains one of the elements R, L, C. The black box is connected to 220 V as supply. The current is I, when a capacitance of 0.1 F is connected in series between the source and box, the current is 2I. The elements is
resistance
inductance
capacitance of 0.5 F
not identifiable form the given data
⇒ ROC of sequence x[n] = (3)^{n} ∪[n] + (4)^{n} ∪[- n - 1]
|z| > 4
3 < |z| < 4
|z| < 4
|z| > 3
⇒ 9's complement of 12_{10} is
21_{10}
87_{10}
78_{10}
76_{10}
⇒ A microstrip line has dielectric having relative permittivity ∈_{r}. The effective dielectric constant is
more than ∈_{r}
equal to 1
less than ∈_{r}
either a or b
⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resulting electric field inside the speciment will be in
direction normal to both current and magnetic field
the direction of current
direction antiparallel to magnetic field
an arbitrary direction depend upon conductivity
⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above
⇒ In Z_{RC} (s) has a pole at s = ∞, the last element in first Foster realization is
R
C
R and C in series
R and C in parallel
⇒ The two conductors of a transmission line carry equal current I in opposite direction. The force on each conductor is
proportional to I
proportional to I^{2}
proportional to distance between the lines
proportional to I^{3}
⇒ A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is a. The period of conduction of SCR and free wheeling diode respectively are
a < ωt < p and p < ωt < (2p + a)
a < ωt < p and p < ωt < 2p
a < ωt < (p + a) and (p + a) < ωt < 2p
a < ωt < p and p < ωt < (2p - a)
⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0
⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform
⇒ How many zone bits are th
2
4
8
16
⇒ PAL stands for
Phase Attenuation by Line
Phase Alternation by Line
Parabolic Alternation by Line
Picture Alternation by Line
⇒ The circuit given below
counter
digital to analog converter
two-bit series-to-parallel converter
analog-to digital converter
⇒ A lag compensator is essentially a
low pass filter
high pass filter
band pass filter
either (a) or (b)
⇒ If the characteristic equation of a closed loop system is s^{2} + 2s + 2, then the system is :
over damped
critically damped
under damped
undamped
⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111
⇒ A quantization error is an essential aspect of ADC
TRUE
FALSE
⇒ Permeance is analogue to
reluctance
conductance
capacitance
resistance
⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output
⇒ The logic function implemented by the following circuit at the terminal OU
P NOR Q
P NAND Q
P OR Q
P AND Q
⇒ Which of the following has unique representation of 0?
sign magnitude
1's complement
2's complement
both (b) and (c)
⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value
⇒ The sensitivity of electromagnetic digital flow meter can be increased by increasing
circumferential width of rotor teeth
radial depth of rotor teeth
thickness of rotor teeth
number of teeth
⇒ As B is increased from zero to about 2T, μ_{r}, of a ferromagnetic material
increase
decrease
first increases then decreases
remains the same
⇒ The contents of the commands register are 23 H. Then port C
is an input port
is an output port
is both input as well as output port
none of the above
⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter
⇒ If output power of a radio receiver is doubled, its volume is increased by __________ dB.
2
3
1
-3