Question is ⇒ 6 bytes means, Options are ⇒ (A) 6 bits, (B) 24 bits, (C) 48 bits, (D) 96 bits, (E) , Leave your comments or Download question paper.

Question is ⇒ 6 bytes means, Options are ⇒ (A) 6 bits, (B) 24 bits, (C) 48 bits, (D) 96 bits, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	6 bytes means
A.	6 bits [Wrong Answer]
B.	24 bits [Wrong Answer]
C.	48 bits [Correct Answer]
D.	96 bits [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ For broadside array, maxima will be obtain at
90°, 270°
180°
45°
at any angle

⇒ For wired AND connection we should use
TTL gates with active pull up
TTL gates with open collector
TTL gates without active pull up and with open collector
any of the above

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒ The effect of source inductance in a 3 phase fully controlled bridge converter is to
decrease the output voltage
increase the output voltage
decrease the output voltage and increase the output current
increase the output voltage and decrease the output current

⇒ In which of these is reverse recovery time nearly zero?
Zener diode
Tunnel diode
Schottky diode
PIN diode

⇒ The number of doped regions in a SCR is
2
3
4
5

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): CE amplifier is the most widely used BJT amplifier

Reason (R): CE amplifier has zero phase difference between input and output

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ If N = 196, the result of the following program will be 196
16
16
196

⇒ Antenna reciprocity is put to use in
radar system
commercial broadcast
TV broadcast system
none of the above

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?
Linear oscillations
Non-linear oscillations
Damped oscillations
No oscillations

⇒ To count 1000 bottles in a milk plant, the minimum number of flip flops requires is
12
10
8
6

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)

⇒ Which of the following circuits come under the class of sequential logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 and 2
1, 2 and 3
3 and 4
4 and 5

⇒ The circuit shown in figure will ac
differentiator
adder
clipper
clamper

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ MUF is depend upon
electron density of the ionospheric layer
11 year sun spot cycle
received frequency by receiver
height of ionospheric layer

⇒ The circuit in figur
positive clamper
negative clamper
positive peak clipper
negative peak clipper

⇒ A Darlington pair has β = 300. If R_E = 1 kΩ and R_L = 100 Ω, the input impedance at the base is approximately
300 k ohm
3 k ohm
100 k ohm
30 k ohm

⇒ The amount of photoelectric emission current depends on the frequency of incident light.
TRUE
FALSE

⇒ A circuit is replaced by its Thevenin's equivalent to find current through a certain branch. If V_TH = 10 V and R_TH = 20 Ω, the current through the branch
will always be 0.5 A
will always be less than 0.5 A
will always be equal to or less than 0.5 A
may be 0.5 A or more or less

⇒ Examine the following truth table. The product of sum from this truth tabl
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)

⇒ Master control facility (MCF) for INSAT-2 series satellites is located at
Madras
New Delhi
Leh
Hassan

⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following
An astable multivibrator
Stable multivibrator
A bistable multivibrator
A J-K flip-flop

⇒ In 8085 microprocessor, the interrupt enable flip-flop is reset by
DI instruction only
system RESET only
interrupt acknowledgment only
all of the above

⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is
3 L + 9 M
1.5 L + 3 M
3 L + 3 M
3 L + 6 M

⇒ In a resistive ac circuit, the current __________ the voltage by __________ .
lags, 90°
lags, 45°
lags, 0°
leads 90°