Question is ⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then, Options are ⇒ (A) R = 10 ns, S = 40 ns, (B) R = 40 ns, S = 10 ns, (C) R = 10 ns, S = 30 ns, (D) R = 30 ns, S = 10 ns, (E) , Leave your comments or Download question paper.

Question is ⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then, Options are ⇒ (A) R = 10 ns, S = 40 ns, (B) R = 40 ns, S = 10 ns, (C) R = 10 ns, S = 30 ns, (D) R = 30 ns, S = 10 ns, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
A.	R = 10 ns, S = 40 ns [Wrong Answer]
B.	R = 40 ns, S = 10 ns [Correct Answer]
C.	R = 10 ns, S = 30 ns [Wrong Answer]
D.	R = 30 ns, S = 10 ns [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Bode diagram (log magnitude plot) of the factor 1/(1 + jωT) in the transfer function the log magnitude for ω << 1/T can be approximated by
0 dB
20 log ωT dB
-20 log ωT dB
none of the above

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0^{+i(t) = 0.5 - 0.125e^-1000t A
i(t) = 1.5 - 0.125e^-1000t A
i(t) = 0.5 - 0.5e^-1000t A
i(t) = 0.375e^-1000t A}

⇒ Consider the instructions

MOV M, B
OUT 4
LDA X

Which of the above uses IO/W cycle?
1 only
1 and 2 only
2 only
3 only

⇒ An increase in temperature increases the width of depletion layer.
TRUE
FALSE

⇒ The reactance of coupling capacitor for AC signals in an amplifier, should be
as low as possible
as high as possible
neither low nor high
either low or high

⇒ In 8085, to disable the whole interrupt system (except TRAP)
the DI instruction may be used
the DO instruction may be used
the INTERRUPT instruction may be used
the El instruction may be used

⇒

Assertion (A): Copper is a good conductor of electricity.

Reason (R): Copper has a face centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Polarization is a measure of
dielectric constant per unit volume
voltage gradient to produce electrical breakdown
product of charge and distance
excess charge density

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ Let JCOKE = 3 and LPEPSI = 5. Consider the statement 8
1
15
10

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ For what positive value of K does the polynomial s⁴ + 8s³ + 24s² + 32s + K have roots with zero real parts?
10
20
40
80

⇒ Impedance inversion may be obtained with
a short circuited stub
a quarter wave line
an open circuited stub
a half wave line

⇒ The hexadecimal number BBC7 is equivalent to decimal number
49761
46791
47691
49761

⇒ A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency f_OH with a second order HP filter having lower cut off frequency f_OL provided
f_OL < f_OH
f_OL > f_OH
f_OH = f_OL
f_OH < 0.5 f_OL

⇒ The holes diffuse from P-region to the N-region in a P-N junction diode because
there is greater concentration of holes in the P-region as compared to N-region
there is greater concentration of holes in the N-region as compared to P-region
the free electrons in the N-region attract them
potential difference facilities such transfer

⇒ Which configuration has high input impedance and low output impedance?
CB
CE
CC
CB and CE

⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ Which of the following is a valid real constant?
1281
1281
KM
11821

⇒ The units of the spectrum obtained be Fourier transforming the covariance function of a stationery Stochastic Process is
Power per Hz
energy per Hz
Power per sec
Energy per second

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ A combination circuit is one in which the output depends on
input combination at that time
input combination and previous output
input combination and previous input
present output and previous output

⇒ In 8085 the data is stored in the stack on
First in First Out basis
Last in First Out basis
First in Last Out basis
Last in Last Out basis

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ In figure, the total power consume
10 W
12 W
16 W
20 W

⇒ In the periodic train of rectangular pulses F₀ = (V₀/T)d
TRUE
FALSE

⇒ The phase of colour subcarrier burst in PAL is along the axis at
+180°
-180°
±180°
±45°

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math