Question is ⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is, Options are ⇒ (A) 0, (B) 1, (C) 32, 767, (D) 65, 535, (E) , Leave your comments or Download question paper.

Question is ⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is, Options are ⇒ (A) 0, (B) 1, (C) 32, 767, (D) 65, 535, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
A.	0 [Wrong Answer]
B.	1 [Correct Answer]
C.	32, 767 [Wrong Answer]
D.	65, 535 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A telephone user while talking to a person via a satellite has to wait for reply for about __________ millisecond.
100
270
470
540

⇒ In 8085 the instruction MOV A, M is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ In home tape recorders the tape width is 2 inches.
TRUE
FALSE

⇒ The input resistance of JFET ideally approaches
zero
1 ohm
100 ohm
infinity

⇒ A 3 bit binary adder can add
2 bits
2 bits
3 bits
8 bits

⇒

Assertion (A): An amorphous material is obtained when mobility of atoms is inhibited during solidification.

Reason (R): Crystalline state is a natural state for most solids.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the follo
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ The word size accessible at a time from the memory subsystem depends on
width of data bus
width of address bus
width of control bus
both (b) and (c)

⇒ In a single stage differential amplifier, the output offset voltage is mainly dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ When narrow current pulses drive a high Q resonant circuit the voltage across the circuit looks like
narrow pulses
half sine wave
almost sine wave
either (a) or (b)

⇒ The number of select lines in a 16 : 1 multiplexer are
4
3
2
1

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ Find I for circuit shown b
0.125
0.0416666666666667
0.0833333333333333
0

⇒ The application of gate signal decreases the break over voltage of on SCR.
TRUE
FALSE

⇒ When a single phase dual converter is operating in circulating current mode
both converters are working as rectifiers simultaneously
one converter is always working as rectifier and the other as inverter
only one converter is working at one time
both converters are either working as rectifiers or as inverters simultaneously

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the cut off frequency for dominant mode.
4 GHz
7.5 GHz
5 GHz
10 GHz

⇒ A step voltages is applied to RLC series circuit having R = 2 Ω, L = 1 H and C = 1 F. The transient current response will be
over damped
critically damped
under damped
any of the above depending the magnitude of voltage

⇒ In a microprocessor
one machine cycle is equal to one clock cycle
one clock cycle consists of several machine cycles
one machine cycle consists of several clock cycles
one machine cycle is always less than one clock cycle

⇒ The maximum permissible distance between two samples of a 10 kHz signal
100 μ sec
50 μ sec
10 μ sec
none

⇒ Point out the false statement
impulse noise voltage does not depend on bandwidth
thermal noise is independent of frequency at which it is measured
industrial noise is mostly of impulse type
space noise is observable at frequencies in the range of 8 MHz and higher

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒ The contents of the program counter after the call operation point to the first instruction on
stack
subroutine
either of the above
none of the above

⇒ Which one of the following is applicable to any network-linear or non-linear, active or passive, time-varying or invariant - as long as Kirchhoff laws are not violated?
Tellegen's theorem
Reciprocity theorem
Maximum power transfer theorem
Superposition theorem

⇒ A 4 bit counter with four flip-flops will count upto decimal
8
15
31
63

⇒ For overdamped systems a quadratic factor in transfer function can be replaced by two first order factors with real poles
TRUE
FALSE

⇒ If a common emitter amplifier with an emitter resistance R_C has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
50 kΩ
0.98 kΩ
50 Ω
0.98 Ω

⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor
low leading
low lagging
high leading
very low lagging

⇒ A microprocessor with a 16 bit address bus is used in a linear memory selection configuration. Address bus lines are directly uses as chip selects of memory chips with 4 memory chips the maximum addressable memory space is
64 k
16 k
8 k
4 k

⇒ In microwave system, waveguide twists
change the plane of polarization of a propagating wave
change the direction of a propagating wave
change the mode of a propagating wave
both (b) and (c)