Question is ⇒ 26810 = __________ ., Options are ⇒ (A) 10A16, (B) 10B16, (C) 10C16, (D) 10D16, (E) , Leave your comments or Download question paper.

Question is ⇒ 26810 = __________ ., Options are ⇒ (A) 10A16, (B) 10B16, (C) 10C16, (D) 10D16, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	268₁₀ = __________ .
A.	10A₁₆ [Wrong Answer]
B.	10B₁₆ [Wrong Answer]
C.	10C₁₆ [Correct Answer]
D.	10D₁₆ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is not a valid variable in FORTRAN 77?
BRG
VS
VS 3A
3 VSA

⇒ Turn on time of a transistor switch is equal to sum of (where t_r is rise time, t_d is delay time)
t_s - t_r
t_s - t_f
t_d + t_r
2t_r

⇒ If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is
0.04
0.08
0.16
0.32

⇒ Zoning is used with a dielectric antenna in order to
permit pin-point focusing
reduce the bulk of the lens
increase the bandwidth of the lens
correct the curvature of the wavefront from a horn that is too short

⇒ A series RLC circuit has a resonant frequency of 2000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
4000 Hz
2025 Hz
1975 Hz

⇒ Which of the following binary numbers is equivalent to decimal 10?
1000
1100
1010
1001

⇒ VLF waves are used for communication system because
of low power requirement
they are least prone to distortion
they penetrate the ionosphere easily
the transmitting antennas are of convenient size

⇒ The relative stability of a system is given by
gain margin alone
phase margin alone
both phase and gain margins
either (a) or (b)

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ A ripple in collector supply voltage of the output stage of amplifier causes noise.
TRUE
FALSE

⇒ A resistance and an inductance are connected in parallel and fed from 50 Hz ac mains. Each branch takes a current of 5 A. The current supplied by source is
0.416666666666667
7.07 A
0.208333333333333
zero

⇒ In a multi-processor configuration two coprocessors are connected to host 8086 processor. The instruction sets of the two coprocessors
must be same
may overlap
must be disjoint
must be the same as that of host

⇒ If f(t) = r (t - a), F(s) =
e^-as/s²
a/(s + a)
1/(s + a)
e^-as/s

⇒ ROC of sequence x[n] = δ[n] is
Not exist
z = 0
Entire Plane
Entire Plane expect z = 0, z = ∞

⇒ The two terms used to describe performance of a directional coupler are
coupling and directivity
gain and coupling
gain and directivity
gain and isolation

⇒ A narrow band noise show
AM only
AM and FM
FM
PCM

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ The resistance of a metallic wire would
increase as the operating frequency increase
decrease as the operating frequency increase
remain unaffected on increasing the operating frequency
first increase then decrease

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ Generally, the gain of a transistor amplifier falls at high frequency due to the
internal capacitance of the device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P

⇒ Find I in 4 Ω resis
0.0416666666666667
0.5 A
0.75 A
0.95 A

⇒

Assertion (A): A dual converter may be circulating current type or non circulating current type.

Reason (R): In circulating current dual converter only one converter can be operated at one time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Hay's bridge is suitable for inductances having low L/R ratio.
TRUE
FALSE

⇒ Measurement of Hall coefficient enables the determination of
recovery time of stored carrier
type of conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
Fermi level and forbidden energy gap

⇒

Match the following:

	List I		List II
A.	FM	1.	slope-overload
B.	DM	2.	μ law
C.	PSK	3.	Envelope detector
D.	PCM	4.	Capture effect
		5.	Hilbert transform
		6.	Matched filter.

A-5, B-1, C-6, D-4
A-4, B-6, C-1, D-5
A-4, B-1, C-6, D-2
A-6, B-3, C-4, D-2

⇒ The reason for glitches on the outputs of decoding gates on a synchronous counter is
FFs changing states together
FFs changing states one at a time
AND gates not functioning properly
none of the above

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage

⇒ For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
1000 MHz
5000 MHz
14000 MHz
140000 MHz

⇒ A P-N junction offers
high resistance in forward as well as reverse direction
low resistance in forward as well as reverse direction
conducts in forward direction only
conducts in reverse direction only

⇒ The temperature coefficient of resistivity of semiconductors is
positive
negative
may be positive or negative
very low