Question is ⇒ 24 telephone channels are frequency division multiplexed using an SSB modulation. Assuming 3 kHz per channel, the required band width is, Options are ⇒ (A) 8 kHz, (B) 27 kHz, (C) 21 kHz, (D) 72 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ 24 telephone channels are frequency division multiplexed using an SSB modulation. Assuming 3 kHz per channel, the required band width is, Options are ⇒ (A) 8 kHz, (B) 27 kHz, (C) 21 kHz, (D) 72 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	24 telephone channels are frequency division multiplexed using an SSB modulation. Assuming 3 kHz per channel, the required band width is
A.	8 kHz [Wrong Answer]
B.	27 kHz [Wrong Answer]
C.	21 kHz [Wrong Answer]
D.	72 kHz [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the circuit shown in the figure, the time constant RC = 1 ms. The input voltage is V₁(t) = 2 sin 10³ t. The output voltage V₀(t) is equa
sin (10³ t - 45°)
sin (10³ t + 45°)
sin (10³ t - 53°)
sin (10³ t + 53°)

⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has
16 bit registers and 32 bit data bus
16 bit registers and 16 bit data bus
32 bit registers and 32 bit data bus
32 bit register and 16 bit data bus

⇒ Consider the following statements

Dissipative attenuator has a fixed value of attenuation.
Reflective attenuator has a fixed value of attenuation.
Both dissipative and reflective attenuators are available only with fixed attenuation.
Both dissipative and reflective attenuators are available with either fixed or variable attenuation.

Which of the above are correct?
1 only
1 and 2
1, 2 and 3
4 only

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is
apparent power
true power
reactive power
none of the above

⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC

⇒ The entries in the first column of Routh array of a fourth order are 5, 2, - 0.1, 2, 1. The number of poles in the right half plane are
1
2
3
4

⇒ An R-L series circuit is excited by a voltage v(t). The circuit was initially relaxed. Which of the following sources of v(t) would cause maximum current at t = 0⁺?
unit step
unit impulse
unit ramp
unit step plus unit ramp

⇒ The derating factor for a BJT transistor is about
0.5 mW/°C
2.5 mW/°C
10 mW/°C
25 mW/°C

⇒ Highest value of autocorrelation function 100 sin 50 pt is
50
zero
100
100/p

⇒ The output of a Piezoelectric crystal has
low amplitude and low impedance
high amplitude and low impedance
low amplitude and high impedance
high amplitude and high impedance

⇒ For maximum unclipped output from a CE amplifier, the Q point should be
at the centre of dc load line
at the centre of ac load line
at the centre of collector current
none of the above

⇒ A Hall effect transducer has K_H = - 1 x 10^-8. If B = 1 Wb/m², I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is
-7.5 x 10^-6 V
-15 x 10^-6
-20 x 10^-4 V
-22.5 x 10^-4 V

⇒ The commonly employed filter in SSB generation is
high pass filter
RC filter
LC filter
mechanical filter

⇒ When satellite radio beam is aimed towards earth, it illuminates on the earth for an oval shaped area called
foot print
beam area
satellite service area
radiated area

⇒ In which of the following instructions of 8085 are the contents of accumulator complemented?
STC
CMC
CMA
RAL

⇒ If the changes in zener current in a voltage regulator circuit are too large, it can be corrected by using a
emitter follower
CE amplifier
capacitor
either (a) or (b)

⇒ For the Infix expression A + B - C + D the Postfix notation is
AB + C - D +
+ AB - C + D
AB - C + D
None of the above

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ The colour coding of a resistors shows 100 K, ± 10%. When the resistance was measured with an ohmmeter, it read
95 K
80 K
120 K
85 K

⇒ In 8355, the ROM is organized as __________ words of 8 bits each.
2000
2048
8355
835

⇒ In synchronous detection of an AM signal
Carrier is completely suppressed
Both side hands are suppressed
Only one side band and part of carrier is suppressed
One side band and full carrier is suppressed

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ MOSFET can be used as a
current controlled capacitor
voltage controlled capacitor
current controlled inductor
voltage controlled inductor

⇒ In n channel JFET
I_D and V_DS are positive but V_GS is negative
I_D and V_GS are positive but V_DS is negative
V_DS and V_GS are positive but I_D is negative
I_D, V_DS and V_GS are all positive

⇒ In an amplifier the stray capacitances assume impedance at low frequencies
TRUE
FALSE

⇒ If two mutually exclusive events A and B can happen in m and n ways, then either A or B can happen in (m + n) ways.
TRUE
FALSE

⇒ At a particular time it is observed that the frequencies of F layer at Delhi is 3 MHz the maximum electron density is
11 x 10¹⁰
1.1 x 10¹⁰
0.11 x 10¹⁰
11 x 10¹²

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Assignment
B.	\| \|	2.	Logical AND
C.	=	3.	Logical OR

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively