Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | 1111 + 11111 = |

A. | 101111 [Wrong Answer] |

B. | 101110 [Correct Answer] |

C. | 111111 [Wrong Answer] |

D. | 11111 [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In the DRAM cell in the figure is the V

_{t}of the NMOSFET is 1 V. For the following three combinations of WL and BL volta

5 V, 3 V, 7 V

4 V, 3 V, 4 V

5 V, 5 V, 5 V

4 V, 4 V, 4 V

⇒

Match the following:

List I (Characteristics) | List II (Device) | ||
---|---|---|---|

A. | Voltage controlled device | 1. | BJT |

B. | Current controlled device | 2. | UJT |

C. | Conductivity modulation device | 3. | FET |

D. | Negative conductance device | 4. | Impatt diode |

A-2, B-3, C-1, D-1

A-2, B-3, C-4, D-1

A-3, B-1, C-2, D-4

A-3, B-1, C-4, D-2

⇒ When performing numerical calculations in floating point arithmetic

- Error may occur due to finite representation of numbers.
- Error may occur due to rounding.
- Error may occur due to finite representation of inherently infinite process.

All

1 and 2 only

1 and 3 only

2 and 3 only

⇒ What will be equipotential surfaces for a pair of equal and opposite line charges?

Spheres

Concentric cylinders

Non-concentric cylinders

None of the above

⇒ In a lead acid battery

the numbers of positive and negative plates are equal

the number of positive plates may be equal to or more than the number of negative plates

the number of positive plates is more than the number of negative plates

the number of negative plates is more than the number of positive plates

⇒ A transmission line terminates in two branches, each of length λ/4, as shown. The branches are terminated by 50Ω loads. The lines are lossless and have the characteristics impedances shown. Determine the impedance Z

_{1}as seen by the so

200Ω

100Ω

50Ω

25Ω

⇒ In a

*p*-

*n*-

*p*transistor operating in forward active mode

base is positive with respect to emitter and collector

base is negative with respect to emitter and collector

emitter is positive with respect to base and base is positive with respect to collector

emitter is negative with respect to base and base is positive with respect to collector

⇒ The time base generator in a CRO gives an output which is

low frequency sinusoidal

high frequency sinusoidal

low frequency rectangular

high frequency sawtooth

⇒ Method of images is applicable to which fields?

Electrostatic fields only

Electrodynamic fields only

Neither electrostatic fields nor electro-dynamic fields

Both electrostatic fields and electro-dynamic fields

⇒ The characteristic equation of flip-flop gives the next state Q

_{N + 1}in terms of present state Q

_{N}and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?

Q

_{N+1}= JQ

_{N}+ KQ

_{N}

Q

_{N+1}= J + KQ

_{N}

Q

_{N+1}= KQ

_{N}+ JQ

_{N}

Q

_{N+1}= K + JQ

_{N}

⇒ CMOS is widely used in

digital wrist watches

analog circuits

high power circuits

all of the above

⇒ SWR for a transmission line is infinity when the load is

- Short circuit
- Complex impedance
- Open circuit
- Pure reactance

1, 3, 4 are correct

1 and 3 are correct

2, 3, 4 are correct

1, 2, 4 are correct

⇒ The resistivity of intrinsic semiconductor material is about

10

^{5}ohm-m

10

^{3}ohm-m

100 ohm-m

1 ohm-m

⇒ In a transistor the minimum and maximum values of β

_{dc}are 100 and 121. The proper value of β

_{dc}to be used to locate Q point is

100

121

110.5

110

⇒ The filter in figure, uses ideal op-amp. I

low pass filter

high pass filter

band pass filter

band stop filter

⇒ Binary 1000 multiplied by binary 1000 gives

10000

100000

1000000

10000000

⇒ The inverse Laplace transform of 1/(

*s*-

*a*)

^{2}is

*e*

^{at}*t*

*e*

^{at}*t*

^{2}

*e*

^{at}*e*/

^{at}*t*

⇒ Y = A + A B is the same as

Y = AB

Y = A + B

Y = A + B

Y = A + B

⇒ Entropies associated with an extremely unlikely message and that with an extremely likely message are respectively

0 and 0

1 and 1

1 and 0

0 and 1

⇒ At frequencies of 10 MHz and higher the impedance represented by ground is primarity

resistive

inductive

capacitive

partly resistive and partly capacitive

⇒ A lag compensator provides attenuation in

very low frequency range

low frequency range

high frequency range

none of the above

⇒ Which of the following wave remains unaffected during day and night?

Tropospheric wave

Sky wave

Ground wave

None of the above

⇒ For the current wave

*i*= 10 + 10 sin θ, the rms value is

0.416666666666667

12.247 A

20 A

14.14 A

⇒ The temperature below which certain materials are antiferromagnetic and above which they are paramagnetic is called

Weiss temperature

Curie temperature

Neel temperature

None of the above

⇒ The addressing mode depicted in the given figur

direct

register

register indirect

implicit

⇒ The force required to initiate motion between two contacting surfaces is called

coulomb friction

viscous friction

static friction

none of the above

⇒ The saturation current in a semi-conductor diode

depends on forward voltage

depends on reverse voltage

is due to thermally generated minority carriers

none of the above

⇒ The frequency of oscillation in a backward wave oscillator can be changed by

varying the voltage which controls beam velocity

varying the beam current

both by varying the beam current and by light varying the voltage which controls beam velocity

changing the rate of thermionic emission

⇒ In a klystron amplifier dc electron velocity is

*v*

_{0}and dc electron charge density is r

_{0}the dc beam current is

r

_{0}

*v*

_{0}

r

_{0}

^{/}

*v*

_{0}

*v*

_{0}

^{/}r

_{0}

(

*v*

_{0}

^{/}r

_{0})

^{2}

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to

inductive effect of current carrying conductors

capacitive effect of current carrying conductors

both inductive and capacitive effects

none of the above