Question is ⇒ 110.112 x 1102 = __________ 10, Options are ⇒ (A) 40.5, (B) 30.5, (C) 20.5, (D) 10.5, (E) , Leave your comments or Download question paper.

Question is ⇒ 110.112 x 1102 = __________ 10, Options are ⇒ (A) 40.5, (B) 30.5, (C) 20.5, (D) 10.5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	110.11₂ x 110₂ = __________ ₁₀
A.	40.5 [Correct Answer]
B.	30.5 [Wrong Answer]
C.	20.5 [Wrong Answer]
D.	10.5 [Wrong Answer]
View Answer 11 -8 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The most commonly used transistor amplifier circuit is
CB
CC
CE
CE or CC

⇒ Sampling frequency
100 Hz
200 Hz
400 Hz
none of these

⇒ Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
22.324 Ω
22.32 Ω
22.3 Ω
22 Ω

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
sin ω₁t + sin ω₂t

⇒

Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt² is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ The circuit given below
Band stop filter
Band pass filter
Oscillator circuit
All pass filter

⇒ e^-2t is __________ .
energy signal
power signal
neither energy signal nor power signal
both energy and power signal

⇒ A semi-conductor device that behaves like two SCRs is
UJT
MOSFET
JFET
TRIAC

⇒ A function table is required in very large numbers the memory most switched for this purpose would be
ROM
PROM
EPROM
EAROM

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ In a CMOS CS amplifier, the active load is obtained by connecting a
p channel current mirror circuit
n channel transistor
p channel transistor
BJT current mirror

⇒ The duration of sunspot cycle is
1 year
11 years
55 years
100 years

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ The commonly employed filter in SSB generation is
high pass filter
RC filter
LC filter
mechanical filter

⇒ In the given figure the input frequency is such that R << X_c,
v₀ lags v_i by 90°
v₀ leads v_i by 90°
v₀ and v_i are in phase
either (b) or (c)

⇒ The slope of log magnitude asymptote changes by - 40 dB/ decade at a certain frequency and the error between asymptote and actual curve is - 6 dB. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
either a pole or zero at that frequency is present

⇒ The forbidden band in semiconductors is of the order of
6 eV
1 eV
10 eV
0.01 eV

⇒ In auxiliary commutated chopper, the peak value of thyristor current is
equal to peak value of load current
equal to peak value of capacitor current
sum of peak value of load current and capacitor current
none of the above

⇒ Find the odd one out
sweep voltage generator
multivibrators
sine wave oscillators
blocking oscillators

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ When a substance is repelled by a magnetic field it is known as
ferromagnetic
antiferromagnetic
diamagnetic
paramagnetic

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical

⇒ Which of the following is anti-ferromagnetic material?
CrSb
NIO
MnO
All of the above

⇒ Directivity means
maximum directive gain
zero directive gain
minimum directive gain
none of the above

⇒ Stepper motors find applications in
X-Y plotters
numerically controlled machining equipment
printers
all of the above

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒ TE₀₁ mode of propagation of electromagnetic energy
is merely the TE₁₀ mode rotated 90°
is merely the TE₁₀ mode rotated 180°
is the same as TE₁₀ mode
either (b) or (c)